Silicon Labs TS1102-200DB, Current Sensing Amplifier Demonstration Board for TS1102-200

  • RS-stocknr. 894-7064
  • Fabrikantnummer TS1102-200DB
  • Fabrikant Silicon Labs
Datasheets
Wetgeving en compliance
Conform
Land van herkomst: US
Productomschrijving

TS1102 Current-Sense Amplifier Demo Boards

Demonstration boards for the Silicon Labs TS1102 Current-Sense Amplifier. Available in a choice of four gain options; 25, 50, 100 and 200. These boards are fully assembled with your choice of gain and fully tested. The board is configured with an 50 mOhm resistor.

They have three dedicated test points; VBATT, VOUT and Load. These boards include a 47nF capacitor at the VOUT output pin.

The TS1102 are available in 5-pin SOT23 packages.

Current Sensing Amplifiers have a voltage output that is proportional to the volt drop across a very low value resistor, usually in a high-current power rail. Hence they measure the current flowing in that power rail.

Specificaties
Kenmerk Waarde
Analogue Function Current Sensing Amplifier
Kit Classification Demonstration Board
Featured Device TS1102-200
tijdelijk niet op voorraad – nieuwe voorraad verwacht op 30-12-2019, met een levertijd van 2 à 3 werkdagen.
Prijs Each
58,01
(excl. BTW)
70,19
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 58,01
Related Products
This pHAT provides a super affordable high-quality DAC ...
Description:
This pHAT provides a super affordable high-quality DAC for your Raspberry Pi. It pumps out 24-bits at 192KHz from the Raspberry Pi's I2S interface on its 2x20 pin GPIO header. Use pHAT DAC to build a tiny, lush-sounding streaming music ...
The EVB8740 is a PHY Evaluation Board EVB ...
Description:
The EVB8740 is a PHY Evaluation Board EVB that interfaces a MAC controller to the LAN8740 Ethernet PHY via a standard 40-pin MII connector and supports Energy Efficient Ethernet IEE802.3az along with Wake-on-LAN and Cable Diagnostics. The LAN8740 is connected ...
Description:
The XR28V382 is a dual channel UART with a Low Pin Count (LPC) bus interface.For use with the XR28V382IL32-F, the evaluation board has a 32-pin QFN package. 2 Independent UART Channels,Operating temperature -40°C to +85°CWatchdog timer.
The ATULPC-DEMO Wearable Demo Reference Design evaluation kit ...
Description:
The ATULPC-DEMO Wearable Demo Reference Design evaluation kit is a hardware platform for developing IoT and Wearable projects. It features a SAML21 low-power microcontroller, a Bluetooth Smart communications module, and an array of motion and environmental sensors. The wearable demonstration ...