Microchip MCP2551-I/P, CAN Transceiver 1Mbit/s 1-Channel ISO 11898, 8-Pin PDIP

  • RS-stocknr. 402-920
  • Fabrikantnummer MCP2551-I/P
  • Fabrikant Microchip
Wetgeving en compliance

MCP2551 CAN Transceivers

The Microchip MCP2551 is a high-speed CAN Transceiver that can operate at speeds of up to 1 Mbps. Serving as an interface between a CAN Controller and the physical bus, the MCP2551 provides differential transmit and receive capability and is fully compatible with ISO 11898. The MCP2551 is suitable for both 12 V and 24 V systems.


Supports 1 Mbps operation
Slope control input
Implements ISO 11898 physical layer requirements
Suitable for 12 V and 24 V systems
Externally controlled slope for reduced RFI emissions
Permanent dominant detect
Low-current standby operation
High noise immunity due to differential bus implementation

CAN Bus Communication - Microchip

Kenmerk Waarde
Maximum Data Rate 1Mbit/s
Number of Transceivers 1
Standard Supported ISO 11898
Power Down Mode Sleep, Standby
Maximum Supply Current 75 mA
Mounting Type Through Hole
Package Type PDIP
Pin Count 8
Dimensions 10.2 x 7.1 x 5mm
Length 10.2mm
Width 7.1mm
Height 5mm
Maximum Operating Supply Voltage 5.5 V
Maximum Operating Temperature +85 °C
Minimum Operating Supply Voltage 4.5 V
Minimum Operating Temperature -40 °C
135 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
670 op voorraad - levertijd is 1 werkdag(en) (UK-voorraad)
Prijs Each (In a Pack of 5)
(excl. BTW)
(incl. BTW)
Aantal stuks
Per stuk
Per pak*
5 +
€ 0,916
€ 4,58
Related Products
Controller Area Network (CAN or CAN-bus) is a ...
Controller Area Network (CAN or CAN-bus) is a computer network protocol and bus standard designed to allow microcontrollers and devices to communicate with each other without a host computer. It was designed specifically for automotive applications but is now also ...
LIN is a small, serial, slow, and cheap bus system. LIN is based on one master node and a number of LIN slaves (up to 16). It is a low-cost concept for automobile networks, for which it standardizes the transmission ...
The HT12E/D chipset works with an Ir or ...
The HT12E/D chipset works with an Ir or RF transmitter and receiver device to make a 4-button wireless remote control system. 8-bit ID (Address) code set by switchesEncoder sends packet containing ID code and button-pressed data four times on serial ...
The L6362A is an IO-Link and SIO mode ...
The L6362A is an IO-Link and SIO mode transceiver device compliant to PHY2 (3-wire connection) supporting COM1 (4.8 kbaud), COM2 (38.4 kbaud) and COM3 (230.4 kbaud) modes. The output stage can be configured as high-side, low-side or push-pull and it ...