FTDI Chip, USB-to-Audio USB Interface Board - VMUSIC2

  • RS-stocknr. 429-290
  • Fabrikantnummer VMUSIC2
  • Fabrikant FTDI Chip
Wetgeving en compliance
Land van herkomst: TH

FTDI Chip USB To Audio Interface Board

The FTDI Chip USB to audio interface board is a product that not only lets you add USB flash disk interfacing to your product but also allows you to playback MP3 and other popular digital music formats directly from a USB flash disk. This requires only four signal lines plus 5V supply and ground to be connected. Extensions to the Vinculum VDAP command set allow you to play a selected file as well as control the volume, balance, etc. of the sound channel and monitor the status of the file being played. The firmware also allows the VNC1L I/O interface to be selected between the serial UART or SPI using onboard jumper pins.

Features and Benefits

USB Type-A socket to connect USB flash disk
Stereo 3.5mm headphone jack socket for audio playback
Audio line-out connector for audio playback
Jumper selectable UART or SPI interfaces
Traffic indicator LED
Uses extended Vinculum VDAP firmware and command set
Program or update firmware via USB Flash disk or via UART


Ideal for adding MP3 playback from a USB drive
Car audio systems
Audio playback capability from USB flash disks


ANSI/ESD S20.20:2014
BS EN 61340-5-1:2007

Kenmerk Waarde
Kit Classification Interface Board
Kit Name USB-to-Audio
9 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
143 op voorraad - levertijd is 1 werkdag(en) (UK-voorraad)
Prijs Each
(excl. BTW)
(incl. BTW)
Aantal stuks
Per stuk
1 - 4
€ 32,36
5 - 9
€ 30,74
10 +
€ 29,20
Related Products
The LC234X module provides a low cost USB ...
The LC234X module provides a low cost USB to UART bridge using the FT234XD IC to transfer data at up to 3M Baud. Ideal for programming Arduino Pro, ESP modules etc., the pinouts follow the industry standard FTDI TTL cable ...
The VNC2 is the second of FTDI’s Vinculum ...
The VNC2 is the second of FTDI’s Vinculum family of Embedded dual USB host controller devices. The VNC2 device provides USB Host interfacing capability for a variety of different USB device classes including support for BOMS (bulk only mass storage), ...
V2-Eval Board is intended for use as a hardware platform to enable easy evaluation of FTDI“s Vinculum-II VNC2 series of embedded USB Host / Slave controllers. The V2-Eval Board includes all the necessary components required by a user to begin ...
The Vinculo is a dual channel USB Host/Device ...
The Vinculo is a dual channel USB Host/Device Controller is targeted at rapid development and prototyping of USB Host/Device interfaces. An optional Vinculo prototyping board provides add-on expansion board support. The Vinculo features an 8-channel, 10Bit ADC, PWM interface and ...