RS PRO HSS 5 → 20mm Cone Cutter

Datasheets
Wetgeving en compliance
N.v.t.
Land van herkomst: DE
Productomschrijving

Sheet metal hole cutter, spiral tap, blank

HSS hole cutter with spiral tap
For burr-free drilling and planing pipes, sheet metals and profiles, as well as moulding, retro drilling and expanding cut-outs
Suitable for construction steel, stainless steel, non-ferrous metals, Plexiglas, plastic and wood up to 6 mm thick
Crosswise grinding means no centre-punching necessary, drill bits do not run
Diameter guide lasered into the tap, legible even when rotating
Three-faced driving shaft, prevents slipping in the drill chuck

Supplied with

Set, stock no. 499-261 contains 1 x 4 → 20 mm hole cutter and 1 x 5 → 31 mm

Warning

  • Not suitable for aluminium. Use without cooling agents.
Specificaties
Kenmerk Waarde
Head Size 5 → 20mm
Material HSS
Minimum Head Size 5mm
Maximum Head Size 20mm
6 op voorraad - levertijd is 1 werkdag(en)
Prijs 1 Set
33,21
(excl. BTW)
40,18
(incl. BTW)
Set(s)
1 +
€ 33,21
Related Products
Coating provides high wear resistanceFor use on aluminium ...
Description:
Coating provides high wear resistanceFor use on aluminium alloys, sheet metal, plastics and reinforced plastics up to 2mm thick22mm shank lengthMaximum shank diameter 10mm.
High Speed Steel tapered cone cutter for power ...
Description:
High Speed Steel tapered cone cutter for power tool use for drilling clean holes in plastic, PC boards, alloys and sheet metal up to 2mm thick. Shank length 22mm No pilot hole required.
HSS TiAlN-coated hole cutter for particularly hard materials; ...
Description:
HSS TiAlN-coated hole cutter for particularly hard materials; glides easily and not prone to wearFor burr-free drilling and planing sheet metal, pipes and profilesSuitable for construction steel, CrNi steel, non-ferrous metals, Plexiglas, plastic and wood up to 5 mm thickCrosswise ...
RS Pro electricians cone-cut and collar, the perfect ...
Description:
RS Pro electricians cone-cut and collar, the perfect cutting tool for rapid drilling and enlarging holes in thin material. The diameter of the hole increases as the cone-cut advances into the material. Offers clearly marked measurements at 20 mm and ...