Development Kit RGB LED Driver for use with Development and Prototyping of a Wide Range of LED Lighting Applications

Datasheets
Wetgeving en compliance
Conform
Productomschrijving

RGB Driver click is an RGB LED driver, capable of driving RGB LED stripes, LED fixtures and other RGB LED applications that demand an increased amount of current and voltage. Besides the NCP5623B IC, a triple output RGB LED driver IC which uses I2C interface for the communication with a microcontroller (MCU), this Click board™ is equipped with three additional Power MOSFETs with very low RDSON value, which allow this IC to drive power demanding RGB elements, such as the LED strips, LED spotlights and similar RGB LED installations. The IC itself is capable of displaying a large palette of Colours with 32 steps for each of the R, G, and B channels.

2.7 to 5.5 V Input Voltage Range
RGB Function Fully Supported
Programmable Integrated Gradual Dimming
90 mA Output Current Capability
94% Peak Efficiency
Built−in Short Circuit Protection
Provides Three Independent LED Drives
Support I2C Protocol
Embedded OVP / Open Load Protection
This is a Pb−Free Device
Multicolour Illuminations
Portable Back Light
Digital Cellular Phone Camera Photo Flash
LCD and Key Board Simultaneous Drive

Specificaties
Kenmerk Waarde
Accessory Type RGB LED Driver
For Use With Development and Prototyping of a Wide Range of LED Lighting Applications
tijdelijk niet op voorraad – nieuwe voorraad verwacht op 05-03-2020, met een levertijd van 2 à 3 werkdagen.
Prijs Each
14,70
(excl. BTW)
17,79
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 14,70
Related Products
Full support for Vivado and Petalinux design environments667 ...
Description:
Full support for Vivado and Petalinux design environments667 MHz Cortex-A9 processor with tightly integrated Xilinx FPGA (option between Dual Core and Single Core options)512 MB DDR3 memoryArduino shield and Pmod connectors for add-on hardware devicesUSB and Ethernet connectivityLarge array of ...
The SigFox click is a device which carries ...
Description:
The SigFox click is a device which carries the SN10-11, a fully integrated module by InnoComm, allowing connection to a low power wide area network (LPWAN) that enables communication utilizing the Industrial, Scientific, and Medical (ISM) radio frequency band. The ...
No external sense resistor required, single package solutionReduced ...
Description:
No external sense resistor required, single package solutionReduced power loss:0.6 mΩ internal conductor resistance on EX package1.2 mΩ internal conductor resistance on LC packageEconomical low- and high-side current sensingOutput voltage proportional to AC or DC currents ±12.5 A and ±25 ...
No firmware development requiredSimple GUI-based configuratorIntegrated USB transceiver, ...
Description:
No firmware development requiredSimple GUI-based configuratorIntegrated USB transceiver, no external resistors requiredIntegrated clock, no external crystal requiredUSB 2.0 full-speed compatibleData transfer rates up to 3 MbaudUSB Battery Charger Detection (USB BCS 1.2 Specification)Remote wakeup for waking a ...