ABB, Jumper Bar

  • RS-stocknr. 136-3895
  • Fabrikantnummer 1SNA173461R2300
  • Fabrikant ABB
Datasheets
Wetgeving en compliance
Conform
Land van herkomst: FR
Productomschrijving

Not assembled screw jumpers bar, - Allows connection between consecutive blocks, - Perforated jumper bar without captive screw and washer, - The perforated jumper bar must be fitted under the washer and the nut of each block.

2 stud terminals M5 x 19.5 mm 0.768 in,
Equipment: self locking nut + spring washer + washer,
18 mm 0.709 in spacing adding SCH6 or INH3,
Two jumpering options: 14 mm 0.551 in spacing with BJH14 and 18 mm 0.709 in spacing (adding INH3)
with BJH18,
NF F 61-017 designation: BE0018-FF5 (1SNA295012R1700 + SCH6 or INH3).

Specificaties
Kenmerk Waarde
Accessory Type Jumper Bar
For Use With HD16/14.FF5.21 Stud Terminal Block, HD16/14.FF5.21.3 Stud Terminal Block
38 op voorraad - levertijd is 2 werkdag(en).
Prijs Each
2,46
(excl. BTW)
2,98
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 2,46
Related Products
Feed-through Screw terminal blocks for cables with cross ...
Description:
Feed-through Screw terminal blocks for cables with cross section 2.5 to 35 mm². The terminals are equipped with integral anti-slackening protection and guarantee reliable connection in all low voltage installations. • Low profile range of terminals that enables transition from ...
ABB series of double deck DIN Rail terminals ...
Description:
ABB series of double deck DIN Rail terminals with four independent screw clamp connections and are suitable for use with a wide range of cable size. • Space saving• Feed-through connection• Flexibility to snap onto symmetrical and asymmetrical DIN Rails. ...
One key advantage of the W-Series is the ...
Description:
One key advantage of the W-Series is the choice of plug-in (ZQV) or screw-in (WQV) cross-connections within one modular terminal. Saving substantial time in comparison to other screw terminals. Terminals available in a range of coloursScrew-in and a plug-in cross ...
For standard & double deck terminals. Permits transverse ...
Description:
For standard & double deck terminals. Permits transverse connections of up to 10 terminals (easily cut to common fewer terminals). The bar and jumper bolts are pre-assembled. The alternate jumper bar permits the interconnection of consecutive or non-consecutive blocks. Where ...