Weidmuller, 3-Pole Jumper Bar, SAK Series

  • RS-stocknr. 718-0951
  • Fabrikantnummer Q 3 SAK2.5 -337100000
  • Fabrikant Weidmuller
Datasheets
Wetgeving en compliance
Conform
Land van herkomst: DE
Productomschrijving

SAK TS35 Range

High quality, industry standard terminals designed for mounting on symmetrical TS35 (top-hat profile) DIN Rail. With high reliability and variety of designs, the SAK series from Weidmuller make planning easier and optimise safety. The terminals are manufactured from polyamide 6.6 with a working temperature of -50°C to +100°C, and meet the requirements of IEC 60947-1.

Features and Benefits

• AP SAK End plates available in 4 sizes to suit 2.5 mm² to 35 mm² terminals • Partitions available in both beige (RS 755-3725) and blue (RS 718-0914, RS 718-0923, RS 718-0926)
• Flammability class UL 94V-2
• Clamping yoke technology

Approvals

CSA certified, UL listed, NEMKO, ATEX, and IECEx

SAK Series

Terminals manufactured from polymide 6.6 with a working temperature of -50°C to +100°C except the fused terminal block (425-689) which is high grade melamine with a working temperature of -60°C to +130°C. Asymmetric rail (G-profile) to B 5825:1980 EN 50035 mounting

Specificaties
Kenmerk Waarde
Accessory Type 3-Pole Jumper Bar
Series SAK
For Use With Terminal Block
140 op voorraad - levertijd is 1 werkdag(en).
Prijs Each (In a Pack of 10)
Was € 1,50
1,412
(excl. BTW)
1,709
(incl. BTW)
Aantal stuks
Per stuk
Per pak*
10 +
€ 1,412
€ 14,12
*prijsindicatie
Related Products
Feed-through Screw terminal blocks for cables with cross ...
Description:
Feed-through Screw terminal blocks for cables with cross section 2.5 to 35 mm². The terminals are equipped with integral anti-slackening protection and guarantee reliable connection in all low voltage installations. • Low profile range of terminals that enables transition from ...
Standard or feed through rated at 750V . ...
Description:
Standard or feed through rated at 750V . Terminals of the same type may be cross connected using the pre-assembled jumper bars for up to 10 poles (2.5mm-16mm terminals) and 2 poles (35mm terminals).,TSCH partitions fit jumper bar cut outs. ...
For the termination of 3 wire sensors. Common ...
Description:
For the termination of 3 wire sensors. Common connection of the supply rails may be achieved with pre-assembled jumper bars allowing the remaining termination to be used for the sensor signal lead. Non-indicating and indicating versions are available for both ...
Universal terminals moulded in polyamide to fit both ...
Description:
Universal terminals moulded in polyamide to fit both 'G' and 'Top Hat' rail.Screw conductor securing with closed screwdriver shafts. Available conductor acceptance sizes, 2.5mm² to 35mm². The range comprises of grey (phase), blue (neutral), and yellow/green (earth) terminals. A 10-way ...