Staubli 66.9045-33, Component Holder, For Use With 4mm Adapter

  • RS-stocknr. 432-1159
  • Fabrikantnummer 66.9045-33
  • Fabrikant Staubli
Datasheets
Wetgeving en compliance
Conform
Land van herkomst: DE
Productomschrijving

Safety Component Holder

An in-line holder to connect individual components with 4mm safety test leads.

Holder comprises 2x4mm safety plugs and 2x4mm safety sockets rated at 600V (CAT II)
Component solder connections are provided within the screw-together adaptor casing
Components clearly visible through transparent adaptor housing, so ideally suited for instructional use

Specificaties
Kenmerk Waarde
Accessory Type Component Holder
For Use With 4mm Adapter
11 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
10,49
(excl. BTW)
12,69
(incl. BTW)
Aantal stuks
Per stuk
1 - 14
€ 10,49
15 - 49
€ 10,30
50 - 99
€ 9,77
100 - 249
€ 9,25
250 +
€ 8,75
Related Products
IR windows allow safe and effective thermal imaging ...
Description:
IR windows allow safe and effective thermal imaging of fully energised electrical systems through closed panels and doors during routine electrical maintenance / inspection. Arc flash resistant to 50 kA (IEC62271-100 and IEC62271-200)Certified to IP65 (BSEN60529) when open or closedMoisture ...
TESTRANSFO2 is a small, hand held device which ...
Description:
TESTRANSFO2 is a small, hand held device which is used to check the functionality of a tri-phased transformer disconnected from the network. Usable on all distribution transformers. It automatically performs a sequence of tests taking only two min to confirm ...
3-phase current adapter for connecting test instruments to ...
Description:
3-phase current adapter for connecting test instruments to 5-pole CEE outlets. These adapters correspond to 5-pole CEE sockets with nominal current Phase sequence testing with signal lamps Testing for effectiveness of protective measures with five 4mm contact protected sockets.
The Multi Contact CAT II - SKS4-19L series ...
Description:
The Multi Contact CAT II - SKS4-19L series electrical installation tester connecting plugs are fully insulated 4mm safety connecting the bridge with 19mm plug spacing. They have a solid brass gold-plated connector body. The rated voltage and current for the ...