Multi Contact 50.0032-33 Electrical Installation Tester Component Holder, Accessory Type Component Holder

Datasheets
Wetgeving en compliance
Conform
Land van herkomst: FR
Productomschrijving

Ø 4 mm component holder for experimental circuit board SET4

Ø 4 mm safety component holder for experimental circuit board SET4.
Component mounting: welded onto terminals supplied.
Protection level: IP2X.
Available in two-pole or four-pole versions.
For use in education, research and development etc.

Current: 5A
Voltage: 600 V (CAT II)
Contact element: 4 mm banana plug

Standards

IEC 61010 - CAT II

Specificaties
Kenmerk Waarde
Accessory Type Component Holder
For Use With 4mm Adapter
53 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
12,13
(excl. BTW)
14,68
(incl. BTW)
Aantal stuks
Per stuk
1 - 9
€ 12,13
10 - 19
€ 11,53
20 +
€ 10,91
Related Products
Sub-miniature connectors with gold plated contacts. Plug, Socket ...
Description:
Sub-miniature connectors with gold plated contacts. Plug, Socket and Hood are supplied separately to provide maximum system flexibility. The Hood can be fitted to either the Plug or the Socket. The Plug and the Socket are non-reversible. 6.5mm Diameter mounting ...
IR windows allow safe and effective thermal imaging ...
Description:
IR windows allow safe and effective thermal imaging of fully energised electrical systems through closed panels and doors during routine electrical maintenance / inspection. Arc flash resistant to 50 kA (IEC62271-100 and IEC62271-200)Certified to IP65 (BSEN60529) when open or closedMoisture ...
Meggers padded carry case for use with MFT1700 ...
Description:
Meggers padded carry case for use with MFT1700 and MT1800 series of testers. Manufactured from a hard wearing nylon fabric, featuring a main compartment, pocket under the lid for test leads and an external pocket for cables and accessories. • ...
3-phase current adapter for connecting test instruments to ...
Description:
3-phase current adapter for connecting test instruments to 5-pole CEE outlets. These adapters correspond to 5-pole CEE sockets with nominal current Phase sequence testing with signal lamps Testing for effectiveness of protective measures with five 4mm contact protected sockets.