WIZnet Inc W5200, Ethernet Controller, 10 Mbps, 100 Mbps MDI/MDIX, SPI, 3.63 V dc, 48-Pin QFN

  • RS-stocknr. 758-1048
  • Fabrikantnummer W5200
  • Fabrikant WIZnet Inc
Datasheets
Wetgeving en compliance
Conform
Land van herkomst: KR
Productomschrijving

Ethernet Controllers

The 7100A device is an Ethernet controller SoC featuring an 'un-attackable' hardware network engine for preventing network attacks such as flooding, spoofing and injection. The W5200 device does not have the on-chip microcontroller and needs to be connected to an external host via an SPI serial bus.

iMCU W7100A Ethernet Controller SoC
8051-core SoC with hardwired TCP/IP protocol stack, MAC and PHY
Hardwired TCP/IP Protocols: TCP, UDP, ICMP, IPv4 ARP, IGMP, PPPoE
Support for ADSL connection (PPPoE Protocol with PAP/CHAP Authentication mode support)
10BaseT/100BaseTX Ethernet PHY Embedded
Support for Auto-Negotiation (Full/Half Duplex)
Support for Auto-MDIX
Code memory: 2KB Boot ROM, 64KB Flash EPROM
Data Memory: 256B Flash EPROM, 64KB RAM
Memory Lock Function
Up to 4 x 8-bit GPIO Ports (3.3V logic level, 5V tolerant, with Pull-Up/Pull-Down)
Full-duplex UART
Programmable Watchdog Timer
DoCD & trade compatible debugger
Power-Down mode
Power supply: +3.0V to +3.6Vdc
Operating temperature range: -40 to +80°C
Package: QFN64 (RS 758-1045)

iEthernet W5200 Ethernet Controller
Hardwired TCP/IP Protocols: TCP, UDP, ICMP, IPv4 ARP, IGMP, PPPoE
Support for ADSL connection (PPPoE Protocol with PAP/CHAP Authentication mode support)
10BaseT/100BaseTX Ethernet PHY Embedded
Support for Auto-Negotiation (Full/Half Duplex)
Support for Auto-MDIX
Host Communication: High Speed Serial Peripheral Interface (SPI Mode 0,3)
Internal 32KB RAM memory for TCP/IP packet processing
Power-Down mode with Wake-on-LAN
Power supply: +3.0V to +3.6Vdc
Operating temperature range: -40 to +85°C
Package: QFN48 (RS 758-1048)

Ethernet Communications

A range of Ethernet communications controllers, transceivers and switching ICs

Specificaties
Kenmerk Waarde
Physical Network Type 10BaseT, 100BaseTX
Host Interface SPI
Network Interface MDI/MDIX
Communication Mode Full Duplex, Half Duplex
Data Rate 10 Mbps, 100 Mbps
Loopback Mode Internal
Mounting Type Surface Mount
Package Type QFN
Pin Count 48
Auto-Negotiation Yes
Typical Operating Supply Voltage 3.63 V dc
Dimensions 7 x 7 x 0.7mm
Maximum Operating Temperature +85 °C
Length 7mm
Minimum Operating Temperature -40 °C
Width 7mm
Height 0.7mm
tijdelijk niet op voorraad – nieuwe voorraad verwacht op 09-02-2021, met een levertijd van 2 à 3 werkdagen.
Prijs Each
4,44
(excl. BTW)
5,37
(incl. BTW)
Aantal stuks
Per stuk
1 - 9
€ 4,44
10 - 19
€ 3,96
20 - 49
€ 3,85
50 - 249
€ 3,75
250 +
€ 3,66
Verpakkingsopties
Related Products
Linear Technology’s RS485 standards are widely used in ...
Description:
Linear Technology’s RS485 standards are widely used in local networks as well as data transfer over long distances and they are ideal in industrial and commercial applications. The Profibus (Process Field Bus) protocol is carried out for fieldbus solutions in ...
High-frequency clock and data signal multiplexer (MUX) devices ...
Description:
High-frequency clock and data signal multiplexer (MUX) devices capable of operating at speeds of up to 10 GHz with extremely fast rise and fall times. Various input and output configurations and logic-level standards are available, including CML, ECL, PECL, LVPECL ...
WIZnet's range of Embedded Ethernet controller Chips, which ...
Description:
WIZnet's range of Embedded Ethernet controller Chips, which inlcudes the following:. RTL8201CP-VD-LF is a single chip/single port PHYceiver with an MII (Media Independent interface)/SNI(Serial Network Interface) and implements all 10/100M Ethernet Physical-layer functions. A PECL interface is supported to connect ...
WIZnet's range of Embedded Ethernet controller Chips, which ...
Description:
WIZnet's range of Embedded Ethernet controller Chips, which inlcudes the following:. RTL8201CP-VD-LF is a single chip/single port PHYceiver with an MII (Media Independent interface)/SNI(Serial Network Interface) and implements all 10/100M Ethernet Physical-layer functions. A PECL interface is supported to connect ...