RS Components
Onze website gebruikt cookies en soortgelijke technologieën om u nog beter van dienst te zijn bij het zoeken of het plaatsen van een bestelling, voor analytische doeleinden en om advertenties te personaliseren.

RE315-HP, Single Sided DIN 41612 C Eurocard PCB FR2 1mm Holes, 2.54 x 2.54mm Pitch, 160 x 100 x 1.5mm

45 - levertijd is 1 werkdag(en)
Add to Basket

Prijs Each

€ 3,58

(excl. BTW)

€ 4,33

(incl. BTW)

Aantal stuks


Roth Elektronik
Land van herkomst:
Aantal stuksPer stuk
1 - 9€ 3,58
10 - 19€ 3,39
20 - 49€ 3,22
50 +€ 3,06

RE315 Prototype Board

European size (160 ´ 100 mm)
RE315-HP (FR2 laminated paper) coated with solder mask
RE315-LF (FR4 epoxy) lead-free, tin-plated
Dimensions: 1.5 ´ 160 ´ 100 mm
35 μm copper laminate
Hole pattern 2.54 ´ 2.54 mm
Drill hole Ø 1.0 mm
RE315 grid for connector strip complying with DIN 41612 type C-96 / abc
For use with 8 x 16-pin IC sockets

DIN Type Stripboards

Suitable for use with the KM6-II eurocard sub-rack systems

The double-sided microboards are designed for microprocessor applications where compatibility, flexibility, high density and screening are of prime importance. VCC rails and a VCC bus are provided but not connected, so that individual rails may be committed as required. 64//96-way DIN 41612 indirect edge connectors may be fitted at either end.
The 3U (100x160) and 6U (233.4x160) boards are available with plated through holes (pth) as an alternative to the standard types. These boards have the added advantage of linking the top with the bottom pads directly via the holes, thereby dispensing with the need to fit linking pins, etc. Also the integrity of the joint is improved as the solder forms round the component lead on both surfaces, in addition to flowing through the hole. This helps to produce a solid and reliable connection, which is very important in applications where a high degree of vibration may be encountered.
Eurocards are manufactured from either epoxy glass material (blue) to BS4584 Part 3 or 16, or SRBP (synthetic resin bonded paper) material to BS4584 Part 5. Card thickness is 1.6mm. Copper 305g/m2 (1oz/ft2). Holes 1.0mm (0.040in.) dia. are pre-drilled on a 2.54mm matrix and all cards can be used with indirect edge connectors to DIN41612 (see Connectors/Terminals) except SRBP stripboard.


Single-sided microboards have the same wiring pattern as the double-sided types, but omit the ground plane and 0 Volt rails on the component side of the card.

Base MaterialSynthetic Resin Bonded Paper
Number of Sides1
Dimensions160 x 100 x 1.5mm
Copper Thickness35µm
Hole Diameter1mm
Hole Pitch2.54 x 2.54mm
ConnectionDIN 41612 C
FR Material GradeFR2