Turck, 3 → 300 (Oil) cm³/s, 5 → 150 (Water) cm³/s Flow Controller, M12 Connector, Analogue

  • RS-stocknr. 313-2453
  • Fabrikantnummer FCS-G1/2A4P-LIX-H1141
  • Fabrikant Turck
Datasheets
Wetgeving en compliance
N.v.t.
Land van herkomst: DE
Productomschrijving

Analogue Flow Control Sensor

Sensor and signal processor in one stainless steel compact housing
On-delay time: 8s (typical)
Ingress protection to IP67
Simple adjustment via LED bar graph and potentiometer
Output Load 500Ω max.
Switch on time: 1.5s
Fluid temperature range: –25 to +75°C
Ingress protection to IP67
Simple adjustment via LED bar graph and potentiometer

//media.rs-online.com/t_line/L313245-01.gif
//media.rs-online.com/t_line/LD313245-01.gif
//media.rs-online.com/t_line/LI313245-01.gif
Specificaties
Kenmerk Waarde
Maximum Flow Rate 3 → 300 (Oil) cm³/s, 5 → 150 (Water) cm³/s
Electrical Connection M12 Connector
Control Output Analogue
Mounting Style Compact
Supply Voltage 21 → 26 V dc
Display Screen LED
Pipe Diameter Range 1/2 in
Minimum Operating Temperature -20°C
Maximum Operating Temperature +70°C
3 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
444,87
(excl. BTW)
538,29
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 444,87
Related Products
Fluid passes through internal flow straighteners, to stabilize ...
Description:
Fluid passes through internal flow straighteners, to stabilize turbulence, before impacting on the vaned turbine rotor which rotates at a speed proportional to the flow rate. The rotor vanes have stainless steel tips which are detected by a sensor mounted ...
Series IR Precision Regulators are designed to be ...
Description:
Series IR Precision Regulators are designed to be compact and light weight. The maximum set pressure has been expanded from the conventional 0.7MPa to 0.8MPa. Relief flow has been increased by nearly 5 times (compared to SMC IR201, IR401).
SMC series AS*002F, in-line type, compact speed controllers ...
Description:
SMC series AS*002F, in-line type, compact speed controllers with built in one-touch fittings minimize installation time, reduce mounting height, and enable a more compact machine design. These speed controls can be mounted in 4 variations (direct mounting, L-bracket mounting, DIN ...
Two wall mounting control units and adaptor mount ...
Description:
Two wall mounting control units and adaptor mount transmitter module designed to provide precise control of liquid flow quantities. Induces a measured frequency into a transducer which is proportional to the flow rate. Selectable dosage mode, overfill correction, allocation of ...