LED Panel Mount Indicator Bulb Holder, 3 mm Lamp Size, 6.3mm Panel Hole Diameter

  • RS-stocknr. 237-0480
  • Fabrikantnummer A104700AAC
  • Fabrikant Arcolectric
Datasheets
Wetgeving en compliance
Conform
Land van herkomst: TN
Productomschrijving

Panel Mount LED Lampholders

Panel mounting LED holders for two lead 3mm and 5mm LEDs. These brass LED holders have a chrome, black or white anodised finish. LEDs are held in place by a push-fit nylon base for 3mm types or a screw-in nylon base for 5mm types. The 5mm focussing reflector types have a recessed parabolic shroud which focuses the light output. The bottom half of the holder unscrews to allow insertion of the LED. Sealed types give protection to IP66.

Specificaties
Kenmerk Waarde
Lampholder Type Panel Mount
Lamp Type LED
Termination Type Wire Leads
Diameter 7.6mm
Length 13.9 mm
Lamp Size 3 mm
Panel Hole Diameter 6.3mm
Panel Thickness 6.3mm
1725 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
820 op voorraad - levertijd is 1 werkdag(en) (UK-voorraad)
Prijs Each
2,47
(excl. BTW)
2,99
(incl. BTW)
Aantal stuks
Per stuk
1 - 24
€ 2,47
25 - 49
€ 2,10
50 - 99
€ 1,85
100 - 249
€ 1,56
250 +
€ 1,33
Related Products
Supplied complete with adaptors to enable either T1 ...
Description:
Supplied complete with adaptors to enable either T1 LES or T1 Miniature Flange lamp to be used.,White glass-loaded nylon body.,Polycarbonate lens provides a uniformly illuminated area. The chrome-plated bezel is connected to one side of the lamp but is fully ...
877 Series,The nickel plated brass body is supplied ...
Description:
877 Series,The nickel plated brass body is supplied with a solder tag, fixing nut and washer. Electrical connections are made via two insulated solder terminals.The caps construction is a nickel plated brass screw with polycarbonate transparent fresnel lens. The lens ...
Direct supply lampholders which can only be used ...
Description:
Direct supply lampholders which can only be used with appropriately rated filament lamps at the voltage listed. This ensures greater safety/longer life than a mains filament lamp and superior illumination to a neon lamp.,These units are designed to be used ...
Designed to accept either LED or incandescent BA9s ...
Description:
Designed to accept either LED or incandescent BA9s bulbsRecognised under the component program of ULSupplied with O-ring to enhance water sealing capabilitiesNickel plated brass bodyElectrical connections via solder tagsOperating voltage 6 to 120Vac/dc (dependent on chosen bulb voltage).