ON Semiconductor, Type-C Interface Detection Solution Evaluation Board USB-C Evaluation Board for FUSB302

Datasheets
Wetgeving en compliance
Conform
Productomschrijving

The FUSB302 evaluation board (EVB) and included software allows customers a complete platform to evaluate the Type-C interface detection solution the FUSB302 provides. The EVB is designed for both stand-alone operation and connection to test equipment for specific testing requirements. The FUSB302 software provides both fully automatic control and manual control of the FUSB302 functions. With a single connection to a PC and a couple configurations in the GUI, the EVB can function as a source, sink or dual role port. The FUSB302 targets system designers looking to implement a DRP/DFP/UFP USB Type-C connector with low amount of programmability. The FUSB302 does the USB Type-C detection including attach, and orientation. The FUSB302 integrates the physical layer of the USB BMC Power Delivery (PD) protocol to allow up to 100 W of power and role swap. The BMC PD block enables full support for alternative interfaces of the Type-C specification.

Specificaties
Kenmerk Waarde
Interface Function USB-C
Kit Classification Evaluation Board
For Use With FUSB302BMPX
Featured Device FUSB302
Kit Name Type-C Interface Detection Solution Evaluation Board
3 op voorraad - levertijd is 2 werkdag(en).
Prijs Each
58,06
(excl. BTW)
70,25
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 58,06
Related Products
FTDI click is a mikroBUS add-on board for ...
Description:
FTDI click is a mikroBUS add-on board for USB 2.0 to UART or I²C bus or SPI bus two serial interface converters. The featured integrated circuit is FT2232H, a dual high-speed USB 2.0 to UART (Universal Asynchronous Receiver and Transmitter) ...
The KSZ9567R is a highly-integrated, IEEE 802.3 compliant ...
Description:
The KSZ9567R is a highly-integrated, IEEE 802.3 compliant networking device that incorporates a layer-2 managed Gigabit Ethernet switch, five 10BASE-Te/100BASE-TX/1000BASE-T physical layer transceivers (PHYs) and associated MAC units, and two MAC ports with individually configurable RGMII/MII/RMII interfaces for ...
The LC234X module provides a low cost USB ...
Description:
The LC234X module provides a low cost USB to UART bridge using the FT234XD IC to transfer data at up to 3M Baud. Ideal for programming Arduino Pro, ESP modules etc., the pinouts follow the industry standard FTDI TTL cable ...
The UMFT221XA is a development module that converts ...
Description:
The UMFT221XA is a development module that converts USB to 8-Bit SPI/FT1248 interfaceSmall PCB assembly module designed to fit a standard 7.62mm (0.3”) wide 20-pin DIP socketOn board USB 'mini-B' socket allows the module to be connected to a PC. ...