mikroBus Click add-on 2-digit 7-seg LED

Datasheets
Wetgeving en compliance
Conform
Land van herkomst: CS
Productomschrijving

7seg click mikroBUS™

The Click accessory modules plug into the mikroBUS sockets in MikroElektronika microcontroller development boards. The 7seg click is easy to use and lets you add a two digit seven segment display to your device. It features two 74HC595 shift register ICs, green power LED and SMD jumper.

mikroBUS™ form factor
Two 7 segment digits on-board
7seg Click connects with target board via SPI interface
SMD Jumper: Operates on 3.3 V or 5 V power supply
2 x 74HC595 serial-in parallel-out shift registers with SPI interface
Supported in all MikroElektronika compilers.
mikroBUS™ is a specially designed pinout standard with SPI, I2C, Analogue, UART, Interrupt, PWM, Reset and power supply pins

Note

Click board comes with the header strips soldered.

Click mikroBUS™ Display & Graphics Boards

Specificaties
Kenmerk Waarde
LED Technology LED
Kit Classification Add On Board
Kit Name 7seg Click
4 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
8,44
(excl. BTW)
10,21
(incl. BTW)
Aantal stuks
Per stuk
1 - 4
€ 8,44
5 - 9
€ 8,09
10 +
€ 7,78
Related Products
The STMicroelectronics STEVAL-ILL079V1 is an inverting buck-boost LED ...
Description:
The STMicroelectronics STEVAL-ILL079V1 is an inverting buck-boost LED driver evaluation board. The board features the LED6000 current regulator. The LED600 is a monolithic current source with dimming capability, for driving high-power LEDs. The device offers a wide input voltage range, ...
The ON Semiconductor is a single chip, dual-LED ...
Description:
The ON Semiconductor is a single chip, dual-LED ballast shield power management Arduino evaluation board. The dual LED driver designed for high current LEDs that provides a complete solution to drive two strings up to 60V, utilizing two internal independent ...
The STEVAL-ILL061V1 is a high brightness RGB LED ...
Description:
The STEVAL-ILL061V1 is a high brightness RGB LED array driver system evaluation board with local dimming and diagnostics based on LED1642GW independent PWM LED driver controlled through an STM32 microcontroller SPI interface. An ST L7981 DC-DC converter provides the voltages/power ...
The STEVAL-LLL004V1 digitally controlled constant current LED driver ...
Description:
The STEVAL-LLL004V1 digitally controlled constant current LED driver reference design features a PFC stage and two DC-DC converters designed to work in transition mode (TM) for optimal efficiency. The LED driver can deliver 75 W output power and implements both ...