Knightsbridge LEDDIMMER LED Dimmer for use with Flat & Triangular LED Strip

Datasheets
Wetgeving en compliance
Conform
Land van herkomst: CN
Productomschrijving

Triangular Linear LED Lighting

These compact linear LED lighting strips have a triangular cross-section. They are suitable for use in home, office, under kitchen cabinets, shelves, display cases. They are easy to install (mounting clips, screws included). The triangular cross section means that their light output is at a 45 degree angle making them ideal for installation in corners. LED strips utilise high brightness surface mounted LED chips and are available in either cool or warm white light and run on low voltage (24 V) for safety and produce no RF interference and operate silently.

LED strips can be linked (up to 24W per run) with connectors or cable (one cable and one linear connector is supplied with each LED strip). Power supply is required (see RS 739-3510).

To further extend the LED striplight reach, use interconnect power leads (available separately) in a choice of lengths:
739-3514 100mm
739-3526 250mm
739-3523 1000mm
739-3520 2500mm

Also these LED strips are dimmable when used with dimmer (see RS 719-3168).,To connect multiple LED strips in different arrangements an 8-way DC splitter is also available (see RS 719-3165).

Supplied with

2 metal mounting clips, screws, one connector cable and one linear connector

Specificaties
Kenmerk Waarde
Accessory Type LED Dimmer
For Use With Flat & Triangular LED Strip
15 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
44 op voorraad - levertijd is 1 werkdag(en) (UK-voorraad)
Prijs Each
24,01
(excl. BTW)
29,05
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 24,01
Related Products
Ready-for-use resistor to set output current valueCompatible with ...
Description:
Ready-for-use resistor to set output current valueCompatible with LED Driver featuring I-select 2 interface, not compatible with I-select (generation 1)Resistor is base isolatedResistor power 0.25 WCurrent tolerance ± 2 % additional to output current toleranceCompatible with LED Driver series PRE ...
RGB-RP is a RGBW LED Power Repeater designed ...
Description:
RGB-RP is a RGBW LED Power Repeater designed to enable the installation of additional LED tapes within one application. This 6-24V DC/DC unit provides one 4A white and three 2.5A output channels so that the white of an RGBW tape ...
The DMX Bridge can be used to integrate ...
Description:
The DMX Bridge can be used to integrate analog DC dimmer signals into LEDSync or DMX network. The DMX bridges are ideal for retrofitting existing lighting installations. The Pro version offer parameter settings for maximum flexibility and system integration. The ...
The Recom REDIM Triac Dimmer reliably operates with ...
Description:
The Recom REDIM Triac Dimmer reliably operates with low input power. These Dimmers are ideally matched to the RECOM RACT20 LED drivers series and provide a smooth dimming curve and deep dimming down to zero. The Triac Dimmer is designed ...