LED Light shield, 4-channel for Arduino

Datasheets
Wetgeving en compliance
Conform
Land van herkomst: GB
Productomschrijving

4-Channel LED Lighting Shield for Arduino

This lighting shield is capable of driving four high-current channels each containing up to 12 LEDs in series. It is designed for the Arduino UNO but is compatible with all other Ardunio boards and the Raspberry Pi via the I2C interface. Suitable for a wide range of applications including room lighting, accent lighting and aquarium lighting. A built in aquarium mode simulates moonlight, daytime and night cycles using an internal 24 hour timer.

Arduino UNO shield standard form factor
Four LED channels each with 350mA constant-current drivers
Up to 12 LEDs in series per channel
Communication via 400kHz serial I2C bus
Jumper-selectable I2C address
Jumper-selectable I2C pull-ups (Not required for Raspberry Pi)
Up to four shields can be linked together via the I²C bus
Screw connector for LED power supply
Operating temperature range: 0 to +70°C
Dimensions: 56.25 x 53.5 x 12mm

Note

The supplied LED module will require a 12V @ 500mA power supply. As the shield uses a constant-current drive, the LED power supply voltage is given by the formula V = n x 4 where n is the number of series LEDs in a channel.

Supplied with

RGBW 4W 340lumen lighting module with heatsink, featuring OSRAM OSLON LEDs

Specificaties
Kenmerk Waarde
Kit Classification Shield
For Use With Arduino
Kit Name 4-Channel LED Lighting
1 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
105,16
(excl. BTW)
127,24
(incl. BTW)
Aantal stuks
Per stuk
1 - 4
€ 105,16
5 +
€ 103,06
Related Products
The MCP1630 Boost Mode LED Driver Demo Board ...
Description:
The MCP1630 Boost Mode LED Driver Demo Board is a step-up, switch-mode, dc-dc converter used for power LED applications. The demo board provides a 350mA or 700mA constant current source with jumper selection. The operating supply is 9Vdc to 16Vdc ...
Description:
The Infineon MR16 3W BOARD is a control board for MR16 low voltage halogen replacement lamps with the ILD4035 hysteretic step down LED IC driver. The control board has 2 input pins to connect a 12V ac power supply and ...
The Infineon EVALLEDICL8201F1 is designed using the LED ...
Description:
The Infineon EVALLEDICL8201F1 is designed using the LED driver ICL8201 and the N-Channel MOSFET transistor IPU50R3K0CE. The ICL8201 cascode topology enables lower system cost and higher system efficiency. Typical applications are GU10 LED Lamp. Supports wide range AC or DC ...
With 4 times as many pixels it makes ...
Description:
With 4 times as many pixels it makes much more complex animations possible, including scrolling text, and even low resolution videos.The bundled ninja diffuser makes the pixels look extra-shiny by providing some subtle diffusion, blurring the lines between each pixel. ...