TE Connectivity 1-2306133-1, LED Mounting Clip & Ring Set for Light Controller Base

Datasheets
Wetgeving en compliance
Conform
Productomschrijving

TE Connectivity (TE)’s ANSI 136.41 compliant 76 mm and 81 mm diameter photo control base assemblies with sleeves and covers in varying heights, providing a total power and signal interface between the photo control and dimming receptacle. This interface can be used in applications such as LED outdoor roadway, street and area lighting fixtures. The base assembly solution includes power twist lock terminals, spring leaf signal terminals and a separately packaged foam gasket.

Translucent covers are configured to transmit daylight to the light sensing device IP66 rated UL 94 flammability rating with a 5V A rated cover Sleeves are designed with side or topside aperture openings to accommodate directional light sensing devices

Specificaties
Kenmerk Waarde
For Use With Light Controller Base
Niet meer leverbaar – bekijk hieronder eventuele alternatieven of neem contact op met onze Customer Service
Related Products
These new devices have been designed to meet ...
Description:
These new devices have been designed to meet the increasing demand for AllnGaP based low current SMD LEDs. The package of the VLM.30.. is the PLCC-2 package. It consists of a lead frame which is embedded in a white thermoplast. ...
These new devices have been designed to meet ...
Description:
These new devices have been designed to meet the increasing demand for AllnGaP based low current SMD LEDs. The package of the VLM.30.. is the PLCC-2 package. It consists of a lead frame which is embedded in a white thermoplast. ...
Panel mounting LED holders for two lead 3mm ...
Description:
Panel mounting LED holders for two lead 3mm and 5mm LEDs. These brass LED holders have a chrome, black or white anodised finish. LEDs are held in place by a push-fit nylon base for 3mm types or a screw-in nylon ...
Ready-for-use resistor to set output current valueCompatible with ...
Description:
Ready-for-use resistor to set output current valueCompatible with LED Driver featuring I-select 2 interface, not compatible with I-select (generation 1)Resistor is base isolatedResistor power 0.25 WCurrent tolerance ± 2 % additional to output current toleranceCompatible with LED Driver series PRE ...