18 W Electronic Fluorescent Lighting Ballast, 220 → 240 V

  • RS-stocknr. 424-0224
  • Fabrikantnummer PC 3/4X18 / 33 COMBO 220-240V
  • Fabrikant Tridonic
Datasheets
Wetgeving en compliance
Conform
Productomschrijving

Replacement HF Ballast and Emergency Kit

Specifically designed to replace existing control gear
Quick and easy installation, only 3 additional wires to be connected (unswitched, live & LED)
High efficiency electronic battery charging with deep discharge battery protection
Suitable for use with linear T8 fluorescent tubes
Operating frequency > 30kHz
The 18W unit has multi way ballast for 3 to 4 tubes, only 1 of which is an emergency
The 2´36W and 2´58W units run both tubes in normal mode, but under emergency conditions runs in single tube operation only
Supplied with combined ballast and emergency module, battery pack with holder and remote mounting LED
Battery packs used comprise high temperature NiCd Accu D Cells in dedicated packs for high temperature operation

Note

Nominal tube diameter - T5=16mm, T8=26mm, T12=38mm

Conversion Kits

Charger/inverter modules for converting fluorescent luminaires into emergency lighting units.,The module and battery packs fit inside most modern fluorescent batten fittings. For luminaires that have limited internal dimensions or that have internal temperatures above 50°C, remote mounting boxes are also available. The remote box is also suitable for converting double luminaires into emergency units, however only 1 tube will operate under emergency conditions. Two live supplies are required for standard operation, one switched, one unswitched. Failure of the unswitched supply operates the changeover circuit bringing on the battery supply. A red LED is supplied with the module for fitting into either the luminaire or remote box, to indicate a healthy battery charging state. The nickel-cadmium battery packs are protected against deep discharge.

Specificaties
Kenmerk Waarde
Wattage 18 W
Number of Lamps 3, 4
Ballast Type Electronic
Supported Lamp Shape T8
Supported Lamp Type Fluorescent
Voltage Rating 220 → 240 V
Dimmable No
High Frequency Yes
Length 424 mm
Width 42 mm
Height 28mm
Minimum Operating Temperature 0°C
Maximum Operating Temperature +50°C
21 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
80 op voorraad - levertijd is 2 werkdag(en) (UK-voorraad)
Prijs 1 Kit
114,90
(excl. BTW)
139,03
(incl. BTW)
Kit(s)
1 +
€ 114,90
Related Products
Lamps can be dimmed down to 3%Can be ...
Description:
Lamps can be dimmed down to 3%Can be dimmed from a low voltage potentiometerFlicker free warm startAutomatic start after lamp replacementIdeal for daylight and/or presence linkingLow noise operation.
The Tridonic PC T8 PRO electronic fixed output ...
Description:
The Tridonic PC T8 PRO electronic fixed output ballasts for fluorescent lamps are ideal for emergency lighting systems. Providing constant light when there are fluctuations in the mains power supply and efficiently shut down when a lamp becomes defected or ...
CELMA Energy Efficiency Index A2 BAT / A2Nominal ...
Description:
CELMA Energy Efficiency Index A2 BAT / A2Nominal life time up to 50000 hours (at 50 °C ambient)Large temperature rangeDevices can operate either 1 or 2 lampsIntelligent Voltage Guard (overvoltage indication and undervoltage shutdown)Constant luminous flux irrespective of fluctuations in ...
Highest CELMA Energy Efficiency Index A2 BATNominal life ...
Description:
Highest CELMA Energy Efficiency Index A2 BATNominal life time up to 100,000 h (at ta 50 °C with a failure rate max. 0.1 % per 1,000 h)Large temperature rangeIntelligent Voltage Guard (overvoltage indication and undervoltage shutdown)Precise lamp operation using adjustment ...