80 W Electronic LED Lighting Ballast, 220 → 240 V

Datasheets
Wetgeving en compliance
Conform
Land van herkomst: IT
Productomschrijving

RS Dimmable Multipower LED Drivers Maxi Jolly 80 Slim HV

The Maxi Jolly 80 Slim HV is a direct current electronic driver, multi-current, for powering LEDs and LED modules. This multi-power LED driver is supplied with dip-switch, for the selection of the output current. The Maxi Jolly 80 Slim HV can power both voltage LED strips and power current LEDs. This power supply delivers high power, with active PFC and flexible selection of the output current.

Multi-power driver supplied with dip-switch for the selection of the output current
Driver for built-in use
It can be used for lighting equipment in protection class I and II.
Active Power Factor Corrector
Analogic input for thermal sensor connection
Current regulation ±5% including temperature variations
Output is not isolated from the input
Stand-by power less than 0,5 W
Protections against overheating, short circuits, mains voltage spikes and overloads
Cannot be switched on and off on secondary circuit for power LED

Note

EN 50172 (VDE 0108)
EN 55015
EN 61000-3-2
EN 61000-3-3
EN 61347-1
EN 61347-2-13
EN 61547
EN 62384
EN 62386

Specificaties
Kenmerk Waarde
Wattage 80 W
Number of Lamps 1
Ballast Type Electronic
Supported Lamp Type LED
Voltage Rating 220 → 240 V
Dimmable Yes
Length 360 mm
Width 21 mm
Height 30mm
Minimum Operating Temperature -25°C
Maximum Operating Temperature +50°C
Dimming Protocol DALI
19 op voorraad - levertijd is 2 werkdag(en).
Prijs Each
69,22
(excl. BTW)
83,76
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 69,22
Related Products
Slim and lightweight electronic high frequency ballasts for ...
Description:
Slim and lightweight electronic high frequency ballasts for controlling T5 fluorescent lamps. Flicker free operation and start after 0.5 secondElectrode heating cut off circuit ensures optimal lamp operation and system efficiencyAutomatic stop circuit shuts failed lamp down within 5 secondsProtected ...
Slim and lightweight electronic high frequency ballasts for ...
Description:
Slim and lightweight electronic high frequency ballasts for controlling T5 fluorescent lamps. Flicker free operation and start after 0.5 secondElectrode heating cut off circuit ensures optimal lamp operation and system efficiencyAutomatic stop circuit shuts failed lamp down within 5 secondsProtected ...
High frequency, electronic microprocessor controlled ballasts for CDM ...
Description:
High frequency, electronic microprocessor controlled ballasts for CDM and other ceramic metal halide lamps giving extended lamp life of 30% against magnetic ballastsEnd of life detectionLow energy lossesPush in contacts for ease of wiringAccurate control of lamp reduces colour differences ...
Charger/inverter modules for converting fluorescent luminaires into emergency ...
Description:
Charger/inverter modules for converting fluorescent luminaires into emergency lighting units.,The module and battery packs fit inside most modern fluorescent batten fittings. For luminaires that have limited internal dimensions or that have internal temperatures above 50°C, remote mounting boxes are also ...