100 → 200W Light Transformer, 230V ac, 12V

Datasheets
Wetgeving en compliance
Conform
Land van herkomst: IT
Productomschrijving

Dimmable Electronic Transformers

IP20 independent electronic transformers for halogen lamps

Class II protection against electric shock
Protected against overheating, voltage spikes and overloads
Secure the transformer using inbuilt screw slots

Low Voltage Lighting Transformers

Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.

Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.

Specificaties
Kenmerk Waarde
Primary Voltage Rating 230V ac
Secondary Voltage Rating 12V
Power Rating 100 → 200W
Dimensions 222 x 54 x 45mm
Length 222mm
Width 54mm
Depth 45mm
Minimum Load Requirement 100W
Maximum Temperature +35°C
Weight 487g
Type Electronic
Dimming Dimming
Dimming Method Trailing Edge
Standards Met EN 55015, EN 60598-1, EN 61000-3-2, EN 61347-1, EN 61347-2-2, EN 61547, VDE 0710-T14
Protection Features Over Voltage Protection, Overheating Protection, Overload Protection, Short Circuit Protection
Maximum Operating Frequency 60Hz
Mounting Type Threaded Slots
Termination Type Screw
Minimum Operating Frequency 50Hz
6 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
36 op voorraad - levertijd is 2 werkdag(en) (UK-voorraad)
Prijs Each
54,45
(excl. BTW)
65,88
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 54,45
Related Products
Chassis mounting mains transformers with twin 115Va.c. 50/60Hz ...
Description:
Chassis mounting mains transformers with twin 115Va.c. 50/60Hz primary windings which may be connected in series for 230V or parallel for 115V operation. The two independent secondary windings may be connected in series or parallel to give a wide range ...
High quality safety and isolating transformers designed for ...
Description:
High quality safety and isolating transformers designed for use in control circuits and general applications Low loss noise laminations Dual standard primary winding 230 / 400Vac with +15V tap for input flexibility Dual secondaries are centre tapped. Earth terminal provided ...
Brought to you by RS Pro, a range ...
Description:
Brought to you by RS Pro, a range of isolation transformers, performing in a single phase solution. Featuring screw connectors for multiple inputs and including robust brackets for screw and/or DIN Rail fixing. High quality isolation transformers are excellent within ...
Brought to you under the trusted RS Brand, ...
Description:
Brought to you under the trusted RS Brand, these single phase isolation transformers are DIN Rail mountable. Fully encapsulated in a moulded resin case, these high quality safety and isolation transformers are intended for use in general applications. • Single ...