DFRobot DFR0225 Romeo V2- an Arduino Robot DC Controller Board for ATmega32u4, L298N for Robotic Applications

  • RS-stocknr. 124-4690
  • Fabrikantnummer DFR0225
  • Fabrikant DFRobot
Datasheets
Wetgeving en compliance
Conform
Land van herkomst: CN
Productomschrijving

Romeo V2 Arduino Robot Board with Motor Driver

Romeo V2 is an Arduino Robot Board (Arduino Leonardo) with Motor Driver for Robotic applications.
The controller board behaves like Arduino Leonardo and is based on the ATmega32u4 chip. Also the board can be program directly from the Arduino IDE 1.0.1 or a later version making it easy to use.

Features:
•Wide operating input voltage
•Directly support XBee and XBee form factor WiFi, bluetooth and RF modules
•ON/ OFF switch to control the system power from external motor power
•3 Digital I/O extensions (D14-D16)
•S1 - S5 switch replace jump cap, allows free use for the GPIO.
•Micro USB instead of A-B USB connector
•Analogue sensor extension port: Orange for Signal, Red for Vcc, Black for GND

Romeo family

Specificaties
Kenmerk Waarde
Kit Name Romeo V2- an Arduino Robot
Kit Classification Controller Board
For Use With Robotic Applications
Motor Type DC
Featured Device ATmega32u4, L298N
117 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
31,21
(excl. BTW)
37,76
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 31,21
Related Products
The STEVAL-ESC001V1 is an electronic speed controller (ESC) ...
Description:
The STEVAL-ESC001V1 is an electronic speed controller (ESC) board for a three-phase Brushless motor (BLDC/PMSM). It demonstrates a sensorless FOC algorithm with speed regulation and active braking. The board is designed to provide fast and efficient propulsion for remote control ...
The STEVAL-IPM08B compact motor drive power board is ...
Description:
The STEVAL-IPM08B compact motor drive power board is based on SLLIMM™ (small low-loss intelligent molded module) 2nd series module ( STGIB8CH60TS-L). It provides an affordable and easy-to-use solution for driving high power motors in a wide range of applications such ...
The STMicroelectronics evaluation board is a new age ...
Description:
The STMicroelectronics evaluation board is a new age device that comes preassembled with H-Bridge. This on-board minimum set of electrical components enables the user to directly connect the load, the power supply and the microcontroller without any additional effort in ...
The STEVAL-FCU001V1 is designed to support quadcopter drone ...
Description:
The STEVAL-FCU001V1 is designed to support quadcopter drone designers. A complete sample FW project allows the designer to begin flying small and medium size quadcopters (with brushed or brushless DC motors) immediately and evaluate the performance of the IMU sensors ...