Microchip ADM00600 Evaluation Board for MCP8025

  • RS-stocknr. 871-1758
  • Fabrikantnummer ADM00600
  • Fabrikant Microchip
Datasheets
Wetgeving en compliance
Conform
Productomschrijving

MCP8025 BLDC Motor Driver Evaluation Board

The Microchip MCP8025 Brushless DC (BLDC) Motor Gate Driver Evaluation Board is a platform designed to demonstrate the drive capabilities of the MCP8025 motor driver device. The board utilises a dsPIC33EP256MC504 processor in combination with the MC8025 to implement a stand-alone 6-step trapezoidal BLDC motor controller.

The board has a terminal block to apply the input voltage with an output header and plated PCB through-hole pads as a means to connect the external motor. Two programming headers are provided for updating the dsPIC33EP256MC504 firmware using either a PICkit programmer/debugger or a MPLAB® in-circuit debugger. Another terminal is provided to allow users to create LIN communication connections to the MCP8025 LIN transceiver.

Features

Input operating voltage range: +6.0V to +19V
Pre-programmed dsPIC33EP256MC504 on board
Drives a three-phase BLDC motor up to 15A and 19V
ON/OFF momentary contact switch
Reset momentary contact switch
Spare user-programmable momentary contact switch
PWM signal LED indicators
PICkit 3 and MPLAB ICD 3 debugger interfaces
Speed control potentiometer
Terminal block for 5V and 12V Hall-effect sensors
LIN terminal block for user communications use
Configurable external MOSFET over-current protection
Configurable PWM dead-time protection
Configurable PWM blanking time for current switching spikes
Complete “C” source code (provided on the Microchip website)

Kit Contents

MCP8025 BLDC Motor Driver Evaluation Board

Note

Motor is not included

Motor Controllers & Drivers, Microchip

Specificaties
Kenmerk Waarde
Kit Classification Evaluation Board
Featured Device MCP8025
4 op voorraad - levertijd is 2 werkdag(en).
Prijs Each
134,49
(excl. BTW)
162,73
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 134,49
Related Products
The STEVAL-IPMNG3Q is a compact 3-phase ac motor ...
Description:
The STEVAL-IPMNG3Q is a compact 3-phase ac motor driver board based on a SLLIMM™-nano (Small Low-Loss Intelligent Moulded Module) 2nd series device. It is designed for driving high-power motors in a wide range of applications such as white goods, air-conditioning, ...
The X-NUCLEO-IHM12A1 is a dual low-voltage brushed DC ...
Description:
The X-NUCLEO-IHM12A1 is a dual low-voltage brushed DC motor driver expansion board based on the STSPIN240 quad half-bridge chip. The device is designed for battery-powered applications and can be forced into a zero-consumption state, yielding a significant increase in battery ...
The X-NUCLEO-IHM13A1 is a low-voltage brushed DC motor ...
Description:
The X-NUCLEO-IHM13A1 is a low-voltage brushed DC motor driver expansion board based on the STSPIN250 quad half-bridge chip. The device is designed for battery-powered applications and can be forced into a zero-consumption state, yielding a significant increase in battery life. ...
The LB1909MC is a low saturation voltage stepping ...
Description:
The LB1909MC is a low saturation voltage stepping motor driver IC. It is optimal for motor drivers in 12V system products. Current consumption 0 in standby modeThe compact package (MFP-10S) is adopted. VCC max = 20V, IO max = 0.8ABIP ...