STMicroelectronics L298P, Brushed Dual Full Bridge Motor Driver, 46 V 4A 20-Pin, PowerSO

Datasheets
Wetgeving en compliance
Conform
Productomschrijving

L298 Dual Bridge Motor Driver

The L298 from ST is an integrated high voltage, high current Dual Full-Bridge Driver. The device is designed to accept standard TTL logic and drive inductive loads in Relays, Solenoids, DC and Stepper Motors. Featured are two enable inputs that allow the L298 to be enabled or disabled independently of the input signals. The emitters of the lower transistors of each bridge are connected and the corresponding external terminal can be used to connect an external sensing resistor. In addition, a supply input is provided so that the logic works at a lower voltage.

Features

Operating supply voltage up to 46 V
Total DC current of up to 4 A
Low saturation voltage
Over-temperature protection
Logical "0" input voltage up to 1.5 V (high noise immunity)

Motor Controllers & Drivers, STMicroelectronics

Specificaties
Kenmerk Waarde
Motor Type Brushed DC
Output Configuration Dual Full Bridge
Maximum IGBT Collector Current 4A
Maximum Collector Emitter Voltage 46 V
Mounting Type Surface Mount
Package Type PowerSO
Maximum Operating Supply Voltage 46 V
Pin Count 20
Minimum Operating Supply Voltage 4.8 V
Inverter Power Rating 25W
Width 11.1mm
Height 3.6mm
Maximum Operating Temperature +130 °C
Length 16mm
Dimensions 16 x 11.1 x 3.6mm
Minimum Operating Temperature -25 °C
88 op voorraad - levertijd is 2 werkdag(en).
Prijs Each (Supplied in a Tube)
4,44
(excl. BTW)
5,37
(incl. BTW)
Aantal stuks
Per stuk
10 - 49
€ 4,44
50 - 149
€ 4,22
150 - 499
€ 3,66
500 +
€ 3,20
Verpakkingsopties
Related Products
The LDLN025 is a 250 mA low-dropout voltage ...
Description:
The LDLN025 is a 250 mA low-dropout voltage regulator, able to work with an input voltage range from 1.5 V to 5.5 V. The typical dropout voltage at 250 mA load is 120 mV. The very low quiescent current, which ...
From Microchip the MTD6508 device is a 3-phase ...
Description:
From Microchip the MTD6508 device is a 3-phase full-wave sensorless driver for brushless DC (BLDC) motors that features a 180° sinusoidal drive, high torque output and silent drive. The MTD6508 is designed to cover a wide range of motor characteristics ...
Description:
The STSPIN240 is a dual brush DC motor driver integrating a low RDS(ON) power stage in a small QFN 3 x 3 mm package.Both the full-bridges implement an independent PWM current controller with fixed OFF time.The device is designed to ...
The device is a full bridge motor driver ...
Description:
The device is a full bridge motor driver intended for a wide range of automotive applications. The device incorporates a dual monolithic high-side driver and two low-side switches. Both switches are designed using STMicroelectronics’ well known and proven proprietary VIPower® ...