Sauter TF 1250-0.1FN FN

  • RS-stocknr. 899-8138
  • Fabrikantnummer TF 1250-0.1FN.
  • Fabrikant Sauter
Datasheets
Wetgeving en compliance
Conform
Land van herkomst: CN
Productomschrijving

Sauter Digital Coating Thickness Gauges

A range of premium hand held Coating Thickness Gauges from Sauter. Designed for use on ferrous or non-ferrous materials.
The offset-accur function allows you to adjust the instrument precisely on the locally measured range by a two-point calibration.
Sauter Digital Thickness Gauges have an internal memory. Offering the ability to store up to 99 measurements which can then be transferred to a computer.

Available with an internal or external sensor
Scan mode
Base plate and calibration foil included
RS-232 data interface
Battery operation 2 x 1.5 V AAA
Minimal base thickness: 0.3 mm

Supplied with

Software
Interface Cable
Hard Storage Case

Parallels, Surface Finish & Hardness

Surface Finish

Any machined component has a surface geometry which consists of three basic elements:

Form or Curvature - Whether the surface has irregular bumps or dimensional changes
Waviness - Whether the surface has regular repetitive ripples or patterns (e.g. milling patterns)
Roughness - The shapes or irregularities that are smaller than, and form part of the waviness pattern (e.g. material micro-structure)

Waviness and roughness are traditionally the most difficult elements to measure when comparing surface finish, however, they have a radical effect on the performance of the finished component. Variations will cause aesthetic appearance changes, component wear variations, oil retention variation etc. Many manufacturers therefore specify a range of roughness values which their components should be manufactured to, often expressed as: Ra, Rq (RMS), RzDIN, Ry, Sm,mm.

Specificaties
Kenmerk Waarde
Tester Type FN
Niet meer leverbaar – bekijk hieronder eventuele alternatieven of neem contact op met onze Customer Service