Omron Connector for use with Smartslice I/O Module

  • RS-stocknr. 145-908
  • Fabrikantnummer 839550000PROFIBUSCONNECTOR
  • Fabrikant Omron
Datasheets
Wetgeving en compliance
Conform
Productomschrijving

Omron SmartSlice Accessories

Omron Smart Slice

Omron's SmartSlice I/O system is compact, intelligent and easy. When used with Omron's CS1/CJ1 DeviceNet master units it is plug-and-work, no configuration tool is required. By using built-in functions such as pre-scaling, totalising, differentiation and alarming in analog I/O units, PLC programming can be minimised.

84mm height and 76mm depth gives a very low-profile to reduce panel space
Easy push-in wiring - no tools required. Each terminal also features a test point
3-part construction means removable terminal block and hot-swappable electronics module
Smart functions for each I/O slice

Specificaties
Kenmerk Waarde
Accessory Type Connector
For Use With Smartslice I/O Module
13 op voorraad - levertijd is 2 werkdag(en).
Prijs Each
Was € 63,15
51,56
(excl. BTW)
62,39
(incl. BTW)
Aantal stuks
Per stuk
1 - 4
€ 51,56
5 - 9
€ 49,98
10 +
€ 48,90
Related Products
Hardware requirements; Windows 3.1 or higher, IBM 386 ...
Description:
Hardware requirements; Windows 3.1 or higher, IBM 386 PC or 100% compatible, 4MB RAM (min.), 4MB free hard disk drive, VGA display, serial port. CQM1-CIF02 is a 2m cable which includes an adaptor and converts a peripheral port on the ...
Module for direct connection of actuator or sensor ...
Description:
Module for direct connection of actuator or sensor signal lines.Direct connection to the ribbon cable by male connector in accordance with IEC 603 1/DIN 41 651.Screw terminal for sensor and actuator connections.Label holder for module identification.DIN rail fitting.
Range of couplers for analogue and digital signals.Enables ...
Description:
Range of couplers for analogue and digital signals.Enables I/O connection to various protocols Modbus, Ethernet, Profibus and Interbus.Configuration simplified with switches or rotary encoders.The joint should be connected to the end of the loop, to guarantee correct transmission of the ...
Connectors and pre-assembled cables for connection of OTB, ...
Description:
Connectors and pre-assembled cables for connection of OTB, FTB, Altivar31 and Lexium 05 via Modbus or CANopen. A network interface module (including CANopen) with 12 inputs x 24V, 6 relay outputs and 2 solid state outputs x 24V-0.3 AAs an ...