Monitran Connector for use with MTN/1185-2P Series

  • RS-stocknr. 533-2245
  • Fabrikantnummer MTN/MH002
  • Fabrikant Monitran
Datasheets
Wetgeving en compliance
N.v.t.
Land van herkomst: GB
Productomschrijving

MTN/1100 Series General Purpose

Used for Data-collector, heavy industry, paper machinery
100mV/g +/-10% Nominal at 80Hz
Frequency from 2Hz up to 10KHz
+/-80G Dynamic acceleration range
Bias Voltage nominal 12 Vdc
Available with TNC Connection (533-2239) or integral cable (533-2251)
IP 67 Stainless Steel body Case
533-2251 includes a 5 meter PTFE Cable - stainless steel over braided
Mounting torque: 8Nm
To use with Glue or M8 Mounting stud
Dimensions (D x L): 22x48mm

Approvals

EEx ia lic BAS02ATEX1057/3

Accelerometers

Vibration sensors use solid-state piezoelectric accelerometers to detect the level of vibration in rotating elements like bearings and gearboxes on machinery such as motors, generators, pumps, fans and compressors. Regular vibration measurements on all critical machines as part of the maintenance regime can detect early signs of failure and provide a way to eliminate these problems. Bearing wear, poor balance and loose mounting all lead to the failure of rotating machinery. Unexpected machinery failure leads to unplanned maintenance costs, loss of production plus potential Health and Safety hazards. They are rugged, adaptable to all types of machinery and conditions including operation in hazardous areas, easy to install and require no maintenance. Used in conjunction with off- and on-line vibration analysers they yield valuable diagnostic information on the machinery's condition and reveal where and when failure may occur allowing pre-emptive maintenance intervention. The dc (velocity) outputs integrate this complex signal into a simple dc signal of 4-20mA proportional to the overall vibration of the machine, ideal for monitoring with all types of industrial controllers.

Specificaties
Kenmerk Waarde
Accessory Type Connector
For Use With MTN/1185-2P Series
Niet meer leverbaar – bekijk hieronder eventuele alternatieven of neem contact op met onze Customer Service
Related Products
Omron's SmartSlice I/O system is compact, intelligent and ...
Description:
Omron's SmartSlice I/O system is compact, intelligent and easy. When used with Omron's CS1/CJ1 DeviceNet master units it is plug-and-work, no configuration tool is required. By using built-in functions such as pre-scaling, totalising, differentiation and alarming in analog I/O units, ...
A cable assembly which connects a PC to ...
Description:
A cable assembly which connects a PC to a LOGO! Controller to download and upload programs written with LOGO! Soft Comfort. • LOGO! TD device directly connectable to all 0BA6 basic modules.• Display with adjustable permanent backlight (on-board and/or TD).• ...
Hardware requirements; Windows 3.1 or higher, IBM 386 ...
Description:
Hardware requirements; Windows 3.1 or higher, IBM 386 PC or 100% compatible, 4MB RAM (min.), 4MB free hard disk drive, VGA display, serial port. CQM1-CIF02 is a 2m cable which includes an adaptor and converts a peripheral port on the ...
Two PPI programming cables for programme uploading, downloading ...
Description:
Two PPI programming cables for programme uploading, downloading and monitoring, at baud rates of 9.6k, 19.2k or 187.5k. Token handling is performed in the cable giving faster and more reliable access to multi-mode networks. RS-232 (serial) version connects directly to ...