SMC Membrane G 1/4 Pneumatic Air Dryer +55°C -5°C, 0.85Mpa

  • RS-stocknr. 667-9315
  • Fabrikantnummer IDG20-F02
  • Fabrikant SMC
Datasheets
Wetgeving en compliance
Conform
Productomschrijving

IDG Series, Membrane Air Dryer

SMC's Membrane air dryer series IDG is available in a single unit or combination unit style. IDG/M models combine a mist separator and micro mist separator with a single unit. IDG/V models combine a regulator with the IDG/M model. Options available include one-touch fitting exhaust of purge air. If purged air is not exhausted around membrane air dryer, air is exhausted with tubing away from its dryer.

A reliable, efficient and an economical alternative to pressure swing and refrigerant dryer technologies.

Compact and lightweight
No power supply required
Discharged air noise reduced with in-built silencer
No vibration or heat discharge
Modular design for additional filtration
Membrane air dryer series
Single unit style
Various sizes available
Port sizes: 1/8" to 1/2"

Note

Flow rates measured as outlet/purge l/min

Dry Air Systems

Compressed air is an essential power source that is widely used throughout industry. This safe, powerful and reliable utility can be the most important part of a production process. However compressed air will contain water, dirt, wear particles, bacteria and even degraded lubricating oil which all mix together to form an unwanted abrasive sludge. This sludge, often acidic, rapidly wears tools and pneumatic machinery, block valves and orifices causing high maintenance and costly leaks. It also corrodes piping systems and can bring a production process to an extremely expensive standstill. Only compressed air that is totally clean and dry will ensure maximum savings.

Specificaties
Kenmerk Waarde
Manufacturer Series IDG
Type Membrane
Inlet Port Size G 1/4
Outlet Port Size G 1/4
Dew Point -20°C
Typical Flow Rate 50 (Purge) L/min, 200 (Outlet) L/min
Maximum Ambient Operating Temperature +55°C
Minimum Ambient Operating Temperature -5°C
Minimum Process Operating Temperature -5°C
Inlet Port Thread Standard G
Process Operating Temperature Range -5 → +55°C
Ambient Operating Temperature Range -5 → +55°C
Minimum Operating Inlet Pressure 0.3MPa
Maximum Operating Inlet Pressure 0.85MPa
Maximum Process Operating Temperature +55°C
1 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
784,57
(excl. BTW)
949,33
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 784,57
Related Products
Designed to provide a cost effective alternative to ...
Description:
Designed to provide a cost effective alternative to hand drying these new dryers have been developed with speed in mind. They provide a rapid drying time of 10-12 seconds, almost half that of competitors products, thus reducing washroom time. Tempest ...
The Mitsubishi Jet Towel Smart Hand Dryer is ...
Description:
The Mitsubishi Jet Towel Smart Hand Dryer is an excellent, class leading hand dryer, with a number of innovative features which result in short drying times, highly efficient running costs and hygienic operation. The Jet Towel Smart is a 'hands-under' ...
Unelevent SL-2008 are a series of warm air ...
Description:
Unelevent SL-2008 are a series of warm air hand dryers with a selection of basic and advanced features.SL-2008 (923-2672) is a push-button type dryer. It will only operate if the triangular button on the front of the device is depressed, ...
Parker Balstron cabinet dryers can reduce the humidity ...
Description:
Parker Balstron cabinet dryers can reduce the humidity in electrical cabinets to less than 10 %. Dry air is supplied to the cabinet at a dew point of less than -18°C removing moisture from inside the cabinet and keeping out ...