Microchip Energy Meter for MCP3905

  • RS-stocknr. 402-100
  • Fabrikantnummer MCP3905RD-PM1
  • Fabrikant Microchip
Datasheets
Wetgeving en compliance
Conform
Productomschrijving

MCP3905 Energy Meter Reference Design

The MCP3905 Energy Meter Reference Design is a stand-alone energy meter. It can act as either a stand alone energy meter, or as the analog front end design for LCD microcontroller based meters. The MCP3905 design is specified with an energy measurement error of 0.1% typical across 1:500 dynamic range for high accurate energy meter designs. This reference design is compliant with EMC requirements per energy metering standards IEC62053 and legacy IEC61036, IEC1046 and IEC687.

Demonstration board is a ready to use single-chip energy meter
Direct connection to line for energy meter, no transformers required
On-board power supply circuitry
Resistive network and Output LED for meter calibration
Resistor shorts for gain and frequency selection

Energy/Power Measurement - Microchip

Specificaties
Kenmerk Waarde
Power Management Function Energy Meter
Kit Classification Reference Design
Featured Device MCP3905
1 op voorraad - levertijd is 2 werkdag(en).
Prijs Each
42,02
(excl. BTW)
50,84
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 42,02
Related Products
The DME D100 & D110 T1 are single-phased ...
Description:
The DME D100 & D110 T1 are single-phased active and reactive Energy Meters for direct connection, for currents up to 40A. These Energy Meters have a standard 1U (18mm wide) modular housing and are supplied with sealable terminal blocks. DME ...
PIC16F1779 CIP Hybrid Power MicrocontrollersOne Power On LED ...
Description:
PIC16F1779 CIP Hybrid Power MicrocontrollersOne Power On LED and Two Status LEDsOne mechanical user switchOnboard debuggerBoard identification in Microchip MPLAB XOne green power and status LED Programming and debuggingVirtual COM port (CDC)One logic analyzer channel (DGI GPIO)I2C Bridge SupportNominal Operating ...
The MCP73833 Li-Ion Battery Charger Evaluation Board contains ...
Description:
The MCP73833 Li-Ion Battery Charger Evaluation Board contains two circuits for evaluation of various device options. Charge Voltage: 4.20VProgrammable Fast Charge Current up to 1000mAPreconditioning of deeply depleted cells: preconditioning threshold voltage: 3.0VPreconditioning Current: 10% of Programmed Fast ...
The MCP73871 Demo Board with Voltage Proportional Current ...
Description:
The MCP73871 Demo Board with Voltage Proportional Current Control is designed to demonstrate Microchip's stand-alone linear Li-Ion battery charger with system power path and load sharing management control. Integrated System Load SharingInput Current Limit Control hardware selected (typical 1650 mA, ...