Maxim MAX14912AKN+ 8 Power Switch IC, High Side Switch / Push-Pull Driver 56-Pin, QFN

Datasheets
Wetgeving en compliance
Conform
Productomschrijving

The MAX14912/MAX14913 have eight 640mA smart high-side switches that can also be configured as push-pull drivers for high-speed switching. The propagation delay from input to switching of the high-side/low-side drivers is 1μs (max). Each high-side driver has a low on-resistance of 230mΩ (max) at 500mA load current at TA = 125°C. The device is configured and controlled either through pins or the SPI interface. The SPI interface is daisy-chainable, which allows efficient cascading of multiple devices. SPI also supports command mode, for the highest detailed diagnostic information.

Low Power and Heat Dissipation
High-Efficiency
Fast Switching Ideal for High-Speed Control Systems
Fast Inductive Load Demagnetization
Robust Operation
Robust SPI Interface with Watchdog and CRC
Open-Wire Detection in High-Side Mode
Low Supply Voltage Warning
Undervoltage Detection
Overvoltage Detection on OUT
Overcurrent Detection
LED Drivers for Visual Fault and Output State Indication

Note

Please note that any defect or non – conformance of this product must be discovered and reported to RS within 20 days of purchase.

Specificaties
Kenmerk Waarde
Power Switch Topology High Side
Power Switch Type High Side Switch / Push-Pull Driver
Switch On Resistance 230mΩ
Number of Channels 8
Maximum Operating Supply Voltage 36 V
Maximum Operating Current 1.5 A, 22 A
Mounting Type Surface Mount
Package Type QFN
Pin Count 56
Maximum Operating Temperature +125 °C
Minimum Operating Temperature -40 °C
Dimensions 8.1 x 8.1 x 0.85mm
Series MAX1491
tijdelijk niet op voorraad – nieuwe voorraad verwacht op 04-05-2020, met een levertijd van 2 à 3 werkdagen.
Prijs Each (In a Tray of 260)
7,611
(excl. BTW)
9,209
(incl. BTW)
Aantal stuks
Per stuk
Per tray*
260 +
€ 7,611
€ 1.978,86
*prijsindicatie
Related Products
Compact low-cost switch ICs which can be used ...
Description:
Compact low-cost switch ICs which can be used to eliminate losses in resistive signal paths connected between high-voltage rails and switching power supply controllers. Typical applications include the feed-forward or feedback signal paths in PFC systems and power converters. The ...
The FPF2290 features a low-RON internal FET and ...
Description:
The FPF2290 features a low-RON internal FET and an operating voltage range of 2.5 V to 23 V. An internal clamping circuit is capable of shunting surge voltages of ±100 V, protecting downstream components and enhancing system robustness. The FPF2290 ...
Description:
The FPF2895 features a 28 V and 5 A rated current limit power switch, which offers Over-Current Protection (OCP), Over-Voltage Protection (OVP), and True Reverse Current Block (TRCB) to protect system. It has low On-resistance of typical 27 mΩ with ...
60 V, 1.5 A PNP BISS loadswitch, PNP ...
Description:
60 V, 1.5 A PNP BISS loadswitch, PNP low VCEsat Breakthrough In Small Signal (BISS) transistor and NPN Resistor- Equipped Transistor (RET) in a SOT457 (SC-74) small Surface-Mounted Device (SMD) plastic package. Low VCEsat (BISS) and resistor-equipped transistor in one ...