Tele Process Pump Controller, 250 V ac, IP20, IP40

  • RS-stocknr. 182-9996
  • Fabrikantnummer G2ASMA20
  • Fabrikant Tele
Datasheets
Wetgeving en compliance
Conform
Land van herkomst: AT
Productomschrijving

Pump control, Alternating/parallel

Alternated access of two pumps or other devices
Even distribution of duty
Parallel duty at high demand
Operation using 1 or 2 input signals (two modes of operation)
Timing offset of the two loads to avoid water hammer effcects
Supply voltage selectable via TR2 power modules
2 separate change over relays for device control
Width 22.5mm
Industrial design
Task
Two pumps are installed at a sewage pumping station that are to be run alternately for equal periods to ensure equal wear.
Solution
The pump switchover system activates the pumps alternately, if needed, the second pump can also be activated so that both run at the same time (parallel operation)
Use/value
Equal wear, and therefore longer service intervals for both pumps
Minimised pump failures through nearly equal number of operating hours
Peak load coverage
Zero-voltage safety in the event of power failures
Applications
Centrifugal Pumps
Sewage Pumps
Water & Waste

Specificaties
Kenmerk Waarde
Supply Voltage 250 V ac
IP Rating IP20, IP40
2 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
142,17
(excl. BTW)
172,03
(incl. BTW)
Aantal stuks
Per stuk
1 - 4
€ 142,17
5 - 9
€ 137,90
10 +
€ 133,64
Related Products
Adjustment of the metering rate directly in l/h ...
Description:
Adjustment of the metering rate directly in l/h or gphSimple tube changeNo problems with very gaseous media or air locksSuitable for viscosities of up to 10,000 mPasSole contact with media in the tubeMany different control options, such as using an ...
A compact and highly efficient motor controller for ...
Description:
A compact and highly efficient motor controller for the RS Pro range of centrifugal micro-pumps. The EQi controller accepts and input voltage of up to 30 volts and pump speed can be controlled from a potentiometer on the board or ...
Hydrovar is an intelligent controller that matches pump ...
Description:
Hydrovar is an intelligent controller that matches pump performance to demand. The pump controller controls the speed of a standard IEC motor by converting the fixed voltage and frequency from the power supply line. The Hydrovar controller can be easily ...
Features a differential pressure switch, dry running cut-out, ...
Description:
Features a differential pressure switch, dry running cut-out, control panel, pressure reservoir and non-return valveStart up pressure 0.5 to 3.5 bar minimum, adjustableDifferential pressure switch controls water pressure in pumped systems and ensures constant flowHelps to prevent boiler cycling and ...