Eccel Technology Ltd RFID Module RWD-MIFARE, Reader/Writer

Datasheets
Wetgeving en compliance
Conform
Land van herkomst: GB
Productomschrijving

MIFARE® RFID Receiver Module

The MicroRWD chip module is a complete RF transponder. Requires connection to the coil antenna.

Tag Reader / Writer Module
Performs all Read / Write functions
Simple RS-232 interface
24pin DIL PCB mounting module
Up to 10cm range on 13.56MHz
Fast Baud rates up to 106K Baud

Specificaties
Kenmerk Waarde
Component Type Reader/Writer
Supported Bus Interfaces TTL
Supply Voltage 4 → 6V
Series MIFARE®
Length 30.5mm
Maximum Operating Temperature +85 °C
Minimum Operating Temperature -40 °C
Width 18mm
142 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
532 op voorraad - levertijd is 1 werkdag(en) (UK-voorraad)
Prijs Each
33,38
(excl. BTW)
40,39
(incl. BTW)
Aantal stuks
Per stuk
1 - 4
€ 33,38
5 - 9
€ 33,15
10 +
€ 31,64
Related Products
Panasonic MN63Y12xx series RFID Tag ICs with built-in ...
Description:
Panasonic MN63Y12xx series RFID Tag ICs with built-in non-volatile memory for use in wireless non-contact near-field communications. The devices feature an encrypted communication function that uses the AES (128 bits) private-key cryptosystem.The MN63Y1212 (824-0708) has only one RF operational mode ...
The TRF7960/61 is an integrated analogue front end ...
Description:
The TRF7960/61 is an integrated analogue front end and data-framing system for a 13.56-MHz RFID reader system. Operating Frequency Range: 13.56MHzRF Output Power: +20 or +23dBmAdjustable ASK modulation rangeReceiver band-pass filter with user-selectable corner frequenciesCompletely integrated protocol handlingDual ...
Description:
The UART-B1 is a low cost full RFID/NFC read/write device with UART interface. Can operate in “host” connected mode or “stand alone” mode. Supports Mifare Classic 1k & 4k, NTAG2xx and Ultralight. Additionally, you can read serial numbers from Mifare ...
Description:
The RS232-B1 v2 is a low cost full RFID/NFC read/write device with RS232 interface that can operate in "host" connected mode or "stand alone" mode. Supports Mifare Classic 1k & 4k, NTAG2xx and Ultralight. Additionally, you can read serial numbers ...