RS PRO Electrolytic Scale Inhibitor, 3L/s

Datasheets
Wetgeving en compliance
Conform
Land van herkomst: GB
Productomschrijving

Electronic Scale Inhibitor

Plugged into the main electrical 230 volt supply the electronic scale inhibitor draws power to the main control unit where it is passed through a 12v transformer and out to the aerial wires, wound around the pipework

Installed on incoming main or on pipework supplying particular areas such as combi boilers, water heaters and electric showers
Fits on hot and cold water pipes,horizontally, vertically or diagonal no plumbing required
Suitable for PVC, copper, lead and iron pipework
Prevent any further build up of hard scale.
Remove any scale already in your hot water system.
Soften scale usually found around taps and in sinks and toilets
One unit can be programmed for 15, 22, 28 35 and 42mm pipework

Contents

Control Unit.
2 x two metre lengths of single cable fixed (antennae aerials).
4 Screws (to mount the unit to a suitable fixture).
4 Cable ties (to secure signal cable when coiled).
Lifetime Guarantee registration card

Specificaties
Kenmerk Waarde
Scale Prevention Mechanism Electrolytic
Maximum Flow Rate 3L/s
5 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
76,89
(excl. BTW)
93,04
(incl. BTW)
Aantal stuks
Per stuk
1 - 4
€ 76,89
5 +
€ 74,53
Related Products
The RS PRO Electromag water conditioner provides industry ...
Description:
The RS PRO Electromag water conditioner provides industry with a cost-effective solution for treating problems with hard scale. Electromagnetic technology effectively reduces existing limescale, preventing new scale build-up, whilst enhancing heat transfer efficiency. The RS PRO Electromag units are available ...
This scale inhibitor unit which should be installed ...
Description:
This scale inhibitor unit which should be installed on cold water lines to prevent limescale from forming and to prolong the life of the system elements.The unit is supplied with fittings for a standard 15mm installation.
The CalGlow scale inhibitor combined magnetic & electrolytic ...
Description:
The CalGlow scale inhibitor combined magnetic & electrolytic dual purpose unit can be installed on both hot and cold water lines to prevent limescale from forming.The unit can be used on 22mm pipework. Maximum temperature: 100 °C.
This dual purpose unit can be fitted on ...
Description:
This dual purpose unit can be fitted on the cold water mains to prevent limescale forming from any heating appliance such as a boiler, shower, or cylinder. The CalCombi Mini induces a single polarity into the water preventing the build ...