- RS-stocknr.:
- 131-1336
- Fabrikantnummer:
- 8.07.01 SWD Isolator
- Fabrikant:
- SEGGER
- RS-stocknr.:
- 131-1336
- Fabrikantnummer:
- 8.07.01 SWD Isolator
- Fabrikant:
- SEGGER
Datasheets
Wetgeving en compliance
Productomschrijving
J-Link ARM SWD Isolator Board
The J-Link SWD Isolator can be connected between a J-Link Probe and an ARM-board with a 20-pin debug connector to provide electrical isolation. This is essential when the development tools are not connected to the same ground as the application.
Compatible Probes
J-Link BASE 131-1319, J-Link PRO, J-Link ULTRA+, J-Link PLUS, Flasher ARM
Features
1kV DC optical isolation
+3.3V and +5Vdc target operation supported
Powered from probe and target
SWD 20-pin connection with SWCLK, SWDIO, SWO and RESET signals
Power consumption on target side: 25mA typical
SWD frequency: Up to 4MHz
3 x LEDs: Probe Power, Target Power and Target RESET
+3.3V and +5Vdc target operation supported
Powered from probe and target
SWD 20-pin connection with SWCLK, SWDIO, SWO and RESET signals
Power consumption on target side: 25mA typical
SWD frequency: Up to 4MHz
3 x LEDs: Probe Power, Target Power and Target RESET
Specificaties
Kenmerk | Waarde |
---|---|
Accessory Type | Adapter |
For Use With | J-Link Probes |