Serial Cable Assembly 500mm Male to Female, USB to Receptacle

  • RS-stocknr. 741-7070
  • Fabrikantnummer C232HM-EDHSL-0
  • Fabrikant FTDI Chip
Datasheets
Wetgeving en compliance
Conform
Productomschrijving

USB 2.0 Hi-Speed to MPSSE Cable, FTDI Chip

The USB 2.0 Hi-Speed to MPSSE cables contain a small internal electronic circuit board, utilising the FTDI FT232H, encapsulated into the USB connector end of the cable. This chip handles all the USB signalling and protocols. The cables provide a fast, simple way to connect devices with 3.3 or 5V digital interfaces to USB.

Based on the single chip USB Hi-Speed FT232H device
USB 2.0 Hi-Speed (480Mbits/Second) and Full Speed (12Mbits/Second) compatible
Entire USB protocol handled on the chip – No USB-specific firmware programming required
USB Type A connector for direct connection to a host or hub
USB bus powered
Fully assisted hardware or X-On / X-Off software handshaking
Synchronous Serial (MPSSE) data rates of up to 30Mbps on JTAG, SPI and I²C
1kByte receive and transmit buffers for high data throughput
Transmit and receive LED drive signals
Adjustable receive buffer timeout
Support for USB suspend and resume
Low operating and USB suspend current Low USB bandwidth consumption
UHCI / OHCI / EHCI host controller compatible
Operating temperature range: -40 to +85°C
Cable length: 1800mm
FTDI’s royalty-free D2XX drivers eliminate the requirement for USB driver development in most cases

Specificaties
Kenmerk Waarde
Connector A Male USB
Connector B Female Receptacle
Length 500mm
Cable Type USB
23 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
4 op voorraad - levertijd is 1 werkdag(en) (UK-voorraad)
Prijs Each
23,02
(excl. BTW)
27,85
(incl. BTW)
Aantal stuks
Per stuk
1 - 9
€ 23,02
10 - 19
€ 21,88
20 - 49
€ 20,76
50 - 99
€ 19,82
100 +
€ 19,33
Related Products
9-pin D-Sub BU to 25-pole D-Sub STPlug housing ...
Description:
9-pin D-Sub BU to 25-pole D-Sub STPlug housing encased for optimum strain reliefScreening wire, connected to foil screen of cable and both plugsExcellent protection prevents data loss and electrical interferences.
Cable jumpers suitable for micro board to board ...
Description:
Cable jumpers suitable for micro board to board interconnections with male/female IDC connectors. Polarised double row connectorsTemperature rating -40 to 105°CUses 0.025 in. pitch 30AWG ribbon cable0.5A current ratingContact resistance: 10 mΩ.
The SCNM925FM 10ft Cross Wired Serial/Null Modem Cable ...
Description:
The SCNM925FM 10ft Cross Wired Serial/Null Modem Cable features one DB9 female and one DB25 male connector, allowing you to connect a 9-pin serial device to a 25-pin serial port, or transfer files from PC-to-PC via a serial connection.Designed to ...
The SCNM9FM 10 ft Cross Wired Serial/Null Modem ...
Description:
The SCNM9FM 10 ft Cross Wired Serial/Null Modem Cable features one DB9 female and one DB9 male connector, allowing you to connect a serial printer to a 9 pin serial port, or transfer files from PC to PC via serial ...