Wago Milivolt Transducer Signal Conditioner, Voltage ATEX, IECEx, 0 → 1000 mV, -100 → 100 mV Input

  • RS-stocknr. 135-7396
  • Fabrikantnummer 857-819
  • Fabrikant Wago
Datasheets
Wetgeving en compliance
Conform
Land van herkomst: DE
Productomschrijving

857 Series Voltage Signal Conditioner

Wago 857 series JUMPFLEX millivolt signal conditioner converts input millivolt signals into an analogue standard signal on the output side.

Features and Benefits

PC configuration interface Switching between measurement ranges is calibrated
Clipping capability allows analogue signal limitation to output end values
Safe 3 way isolation with 2.5 kV test voltage per EN 61140

Wago JUMPFLEX Isolation Amplifiers and Signal Conditioners

Specificaties
Kenmerk Waarde
Input Type Voltage
Output Type Analogue
Signal Conditioner Type Milivolt Transducer
Input Range -100 → 100 mV, 0 → 1000 mV
Output Range 0 → 10 V, 0 → 20 mA
Supply Voltage 24 V dc
Mounting Type DIN Rail
Minimum Operating Temperature -25°C
Maximum Operating Temperature +70°C
Special Features Clipping Capability Allows Analogue Standard Signal Limitation To Upper Range Values
Standards Met ANSI/ISA 12.12.01, BV, Conformity Marking, CULus, DNV, EMC EN 61000-6-2, EMC EN 61000-6-4, EN 61140, GL, IECEx TUN 14.0030 X, NKK, PRS, RoHS Compliant, TUV 14 ATEX 112692 X, UL 508
Module Type Transducer
Termination Push-In
Interface APP Configuration Interface, PC Configuration Interface, Software Configuration Interface
Hazardous Area Certification ATEX, IECEx
Operating Temperature Range -25 → +70 °C
1 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
176,15
(excl. BTW)
213,14
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 176,15
Related Products
RS Pro single or dual trip amplifiers with ...
Description:
RS Pro single or dual trip amplifiers with the facility to arrange each trip so that the alarm condition can be above (high trip) or below (low trip) the set point. The relay can be either energise/de-energise in the alarm ...
The MTLx525 enables an on/off device in a ...
Description:
The MTLx525 enables an on/off device in a hazardous area to be controlled by a volt-free contact or logic signal in the safe area. It can drive loads such as solenoids, alarms, LEDs and other low power devices that are ...
The MTLx532 isolates pulses from a switch, proximity ...
Description:
The MTLx532 isolates pulses from a switch, proximity detector, current pulse transmitter or voltage pulse transmitter located in a hazardous area. It is ideal for applications involving high pulse rates and fast response times, by repeating the pulses into the ...
The MTL MTL5000 series signal conditioner, swith/proximity output ...
Description:
The MTL MTL5000 series signal conditioner, swith/proximity output detector interface. It enables two safe-area loads to be controlled, through relays, by a proximity detector or switch located in a hazardous area. When selected, open or short circuit conditions in the ...