Cam Clutch TFS Series, bore 25mm

  • RS-stocknr. 184-5776
  • Fabrikantnummer TFS25
  • Fabrikant Tsubaki
Wetgeving en compliance
Land van herkomst: JP

TFS Series Cam Clutch is a sprag type clutch designed for press fit installation. Sprag type designs typically have a higher torque capacity than a similarly sized ramp & roller type clutch. TFS has two vertical keyways on the outer race to assist with locating. Outside dimensions are the same as Series 63 ball bearings. This design is ideal for general inner or outer race overrunning applications. Since the TFS Series does not include an integral bearing, installing the TFS Cam Clutch next to a bearing which handles both the axial and radial loads is the typical application. TFS Series ships pre-lubricated with oil.

Kenmerk Waarde
Series TFS
Inside Diameter 25mm
Outside Diameter 62mm
Race Width 24mm
Torque 128Nm
Over-running Speed 1000 (Outer Race) RPM, 2000 (Inner Race) RPM
Keyway Inner Race
3 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
(excl. BTW)
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 177,61