Digi International XB24CZ7UIS-004 ZigBee Module +8dBm -102dBm SPI, UART Serial 2.1 → 3.6V 22 x 34 x 3mm 3mm 22mm

Datasheets
Wetgeving en compliance
Conform
Productomschrijving

XBee ZigBee RF Module

The XBee ZigBee RF module operates in the 2.4GHz ISM Band and allows the formation of a mesh network. With its high receiver sensitivity it can provide long-range line-of-sight communication for up to 1200m.

Carrier frequency: 2.4GHz ISM band with 16 channels
RF Power Output: +5dBm, +8dBm (Boost mode)
Receiver Sensitivity: -102dBm (Boost mode) @ 1% PER
Interference control: Direct Sequence Spread Spectrum (DSSS), Packet Retry/Acknowledgement
OTA Date Rate: up to 250kbps
Host communication: serial UART with RTS/CTS flow control, SPI
Supported network topologies: Point-to-Point, Point-to-Multipoint, Peer-to-Peer & Mesh
Protocol: ZigBee PRO 2007, HA-Ready with support for binding/multicasting
AES-128 encryption
Antenna: RF Pad ( RS 719-3840), External via U.FL (RS 719-3843), PCB (RS 719-3831)
4 channel 10-bit ADC
15 x GPIO pins
Power supply: +2.1V to +3.6Vdc
Operating temperature range: -40 to +85°C
Dimensions: 22 x 34 x 3mm SMT
Applications: Wireless sensor networks, long-range communication for the Internet of Things (IoT)

Approvals

FCC, ETSI

Specificaties
Kenmerk Waarde
Maximum Output Power +8dBm
Receiver Sensitivity -102dBm
Supported Bus Interfaces SPI, UART
Supported Network Interfaces Serial
Supply Voltage 2.1 → 3.6V
Dimensions 22 x 34 x 3mm
Height 3mm
Length 22mm
Maximum Operating Temperature +85°C
Minimum Operating Temperature -40°C
Width 34mm
tijdelijk niet op voorraad – nieuwe voorraad verwacht op 04-11-2020, met een levertijd van 2 à 3 werkdagen.
Prijs Each (In a Tray of 36)
18,378
(excl. BTW)
22,237
(incl. BTW)
Aantal stuks
Per stuk
Per tray*
36 +
€ 18,378
€ 661,608
*prijsindicatie
Related Products
The RFID B1 module is a 13.56MHz sub ...
Description:
The RFID B1 module is a 13.56MHz sub assembly from Eccel Technology Ltd. The product is suitable for embedded applications and computing/ PLC platforms where RFID capability is needed. An on board is a low-power ARM microcontroller which helps manage ...
The Espressif ESP-WROOM-02 is a low-power 32-bit MCU ...
Description:
The Espressif ESP-WROOM-02 is a low-power 32-bit MCU WiFi module. This small SMD module integrates the ESP8266EX WiFi chip and is designed for optimal RF performance. The ESP-WROOM-02 enables you to evaluate and further develop the device for you chosen ...
The Microchip MRF24WN0 is a family of 2.4GHz ...
Description:
The Microchip MRF24WN0 is a family of 2.4GHz 802.11b/g/n Wireless Modules that integrate all the required RF components into one compact form factor. The module includes a Voltage Regulator, Crystal Oscillator, RF Matching Circuitry, Power Amplifier (PA), Low Noise Amplifier ...
WF111-A Bluegiga is a fully integrated single 2.4GHz ...
Description:
WF111-A Bluegiga is a fully integrated single 2.4GHz band 802.11 b/g/n module, intended for portable and battery powered applications, where Wi-Fi connectivity is needed. WF111-A integrates an IEEE 802.11 b/g/n radio, antenna or U.FL antenna connector and SDIO or CSPI ...