3M End Cap Black, Rubber, 30.1mm

  • RS-stocknr. 307-932
  • Fabrikantnummer 804530
  • Fabrikant 3M
Datasheets
Wetgeving en compliance
Conform
Land van herkomst: CN
Productomschrijving

EC series cold shrink end caps

Cold shrink end caps are moulded in black EPR, are UV-resistant and are pre-expanded on an
applicator ring for easy application on-site or in storage areas, without the need for
grease, tools or a torch; they ensure a reliable seal.
They provide excellent resistance to various chemical and atmospheric agents (ultraviolet light, ozone) as well as to abrasion and deformation.
Used to block moisture penetration in all types of cables waiting to be connected or used in trenches, along roads or on cable drums or sheath ends.
Mechanical protection of cable ends.

Specificaties
Kenmerk Waarde
Type End Cap
Inside Diameter Primary 30.1mm
Material Rubber
Colour Black
Shrunk Diameter Primary 15.9mm
105 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
308 op voorraad - levertijd is 1 werkdag(en) (UK-voorraad)
Prijs Each
5,68
(excl. BTW)
6,87
(incl. BTW)
Aantal stuks
Per stuk
1 - 14
€ 5,68
15 - 49
€ 5,39
50 +
€ 5,10
Related Products
Based on the successful and popular standard CPC ...
Description:
Based on the successful and popular standard CPC series, these fully sealed IP65 power connectors utilise precision-formed Powerband contacts that offer a rating of up to 45A for single contacts, in isolation. Manufactured from high strength, impact resistant thermoplastic, rated ...
LV Cable Joints are designed to be used ...
Description:
LV Cable Joints are designed to be used with multicore armoured polymeric low voltage energy cables. Designed for indoor and outdoor use and also for underground and submerged applications. Resin 470W contained in two chamber bags for mixingTransparent mixing bagsTwo ...
The Unarmoured LV Cable Joints can be used ...
Description:
The Unarmoured LV Cable Joints can be used for 1-core up to 5-core non shielded polymeric low voltage energy cables. These joints can be used internally, externally, underground or in submerged environments. Two transparent chamber bags of Resin 40Chamber bags ...
T-shaped moulded parts with 45° or 90° side ...
Description:
T-shaped moulded parts with 45° or 90° side breakouts. Manufactured from heat shrink DR-25 material these moulded parts have good resistance to aggressive chemicals at high temperature. • Provides strain relief, protection and mechanical support• Shrink Ratio 2:1• Flame retardant. ...