RS PRO Galvanised Steel 75 x 75mm Cable Trunking Coupler Flanged Coupler Galvanised Steel

Datasheets
Wetgeving en compliance
N.v.t.
Land van herkomst: GB
Productomschrijving

Flange Coupler

Flange Couplers used for supporting trunking ends to walls or vertical supports, can also be used by connecting into an existing trunking run where it would be difficult to remove the trunking to fit a tee

Fittings

Galvanised Steel

Selection of fittings which enable you to configure your installation manufactured from pre-coated galvanised steel, incorporate quick release style lids. All fittings come supplied complete with fixing screws.

Specificaties
Kenmerk Waarde
Trunking Accessory Type Flanged Coupler
Material Galvanised Steel
Width 75mm
Height 75mm
Dimensions 75 x 75mm
Series Galvanised Steel
52 op voorraad - levertijd is 1 werkdag(en).
Prijs Each (In a Pack of 2)
2,21
(excl. BTW)
2,67
(incl. BTW)
Aantal stuks
Per stuk
Per pak*
2 - 18
€ 2,21
€ 4,42
20 - 98
€ 2,095
€ 4,19
100 +
€ 1,99
€ 3,98
*prijsindicatie
Related Products
BS4568 Part 2 product finish classification.,Class 2 - ...
Description:
BS4568 Part 2 product finish classification.,Class 2 - Black enamelled inside and outside.,Class 3 - Pre-galvanised sheet steel.,Class 4 - Hot dipped galvanised inside and outside. Lids are secured by M5 x 8mm mushroom head screws.
A selection of accessories predominantly for use with ...
Description:
A selection of accessories predominantly for use with steel conduits. For a more general range of accessories (Jack Chain, Locknuts, P clips and Adapters) please see stock no. 621-089 typically.,20 & 25mm Conduit Straps with a galvanised finish can be ...
BS4568 Part 2 product finish classification.,Class 2 - ...
Description:
BS4568 Part 2 product finish classification.,Class 2 - Black enamelled inside and outside.,Class 3 - Pre-galvanised sheet steel.,Class 4 - Hot dipped galvanised inside and outside. Elbows and Tees in malleable iron with various finishesCovers and screws come supplied as ...
There are three alternative methods of fitting trapeze ...
Description:
There are three alternative methods of fitting trapeze hangers to threaded rods as shown below. All three methods are applicable to trapeze hangers for–600-900“€€mm widths but only type ‰ applies to narrower trapeze hangers. The recommended safe working load for ...