TE Connectivity for use with MATE-N-LOK Series

Datasheets
Wetgeving en compliance
Conform
Productomschrijving

TE Connectivity Universal MATE-N-LOK Strain Relief Clamps

A range of Cable clamps / Strain Relief for Mate-N-Lok Connectors. Each article constitutes half of a cable clamp, it is thus necessary to order two of them to facilitate assembly for a complete clamp. The material for these MATE-N-LOK Strain Relief's is a UL 94V-0 or UL 90V-2 rated Nylon.
Stock numbers 680-1903, 710-0090 , 864-9439 are cap housing adapters which anchor the receptacle housing strain reliefs to the housings and prevent distortion of the strain relief when screws are tightened.

Note

Assembly requires two self-tapping screws 3.5 x 10 to 3.5 x 16 (these screws are not supplied)

TE Connectivity Universal MATE-N-LOK™ Range

Specificaties
Kenmerk Waarde
For Use With MATE-N-LOK Series
Series Universal MATE-N-LOK
150 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
500 op voorraad - levertijd is 1 werkdag(en) (UK-voorraad)
Prijs Each (In a Pack of 5)
0,48
(excl. BTW)
0,58
(incl. BTW)
Aantal stuks
Per stuk
Per pak*
5 - 120
€ 0,48
€ 2,40
125 +
€ 0,456
€ 2,28
*prijsindicatie
Verpakkingsopties
Related Products
TE Connectivity Universal Mate-N-Lok splashproof connector interface seals ...
Description:
TE Connectivity Universal Mate-N-Lok splashproof connector interface seals for use with Universal Mate-N-Lok sealed connectors to create a splash proof/immersion proof connection when mating two free hanging connectors. These Universal Mate-N-Lok interface seals are made from silicone rubber and are ...
TE Connectivity Universal Mate-N-Lok connector wire seals essentially ...
Description:
TE Connectivity Universal Mate-N-Lok connector wire seals essentially splash proof/immersion proof an existing universal mate-n-lok connector, two seals and one interface seal is required when mating two free hanging connectors, a closed bottom header is required for wire to board ...
Standard design extraction tool for extracting MATE-N-LOK 3.5 ...
Description:
Standard design extraction tool for extracting MATE-N-LOK 3.5 contacts from connector housings. This standard design extraction tool has a comfortable ergonomic handle design and a pull-out and lock protective cover.
Required to fit seals on Mate-N-Lok connectorsAn insertion ...
Description:
Required to fit seals on Mate-N-Lok connectorsAn insertion tool is recommended if the contacts are used with wires of small cross-section.