Digilent 410-308 Programming Module for use with FPGA Devices

Bekijk deze categorie
Bulkkorting beschikbaar

Subtotaal (1 eenheid)*

€ 47,29

(excl. BTW)

€ 57,22

(incl. BTW)

Add to Basket
selecteer of typ hoeveelheid
Tijdelijk niet op voorraad
  • Verzending vanaf 16 januari 2026
Heeft u meer nodig? Klik op 'Controleer leverdata' voor extra voorraad en levertijden.
Aantal stuks
Per stuk
1 - 4€ 47,29
5 - 9€ 44,93
10 +€ 43,51

*prijsindicatie

RS-stocknr.:
134-6473
Fabrikantnummer:
410-308
Fabrikant:
Digilent
Zoek vergelijkbare producten door een of meer kenmerken te selecteren.
Alles selecteren

Merk

Digilent

Product Type

Development Kit Accessory

Accessory Type

Programming Module

For Use With

FPGA Devices

Standards/Approvals

No

JTAG-SMT2 SMT Programming Module


The JTAG-SMT2 surface-mount programming module allows high-speed programming of Xilinx FPGA devices from a host PC. Users can solder the module directly onto a target board like any other component. Note: The JTAG-SMT2-NC part (RS 134-6473) does not have a USB connector fitted.

Features


• Compatible with all Xilinx tools

• Compatible with IEEE 1149.7-2009 Class T0 - Class T4 (includes 2-Wire JTAG)

• On-board ADP123AUJZ 300mA voltage regulator

• Separate Vref drives JTAG/SPI signal voltages

• Vref can be any voltage between +1.8V and +5V

• USB 2.0 HS port drives JTAG/SPI bus at up to 30Mbit/sec

• JTAG/SPI frequency settable by user

• PC connector: MicroUSB (JTAG-SMT2 only)

• GPIO pin allows processor reset of Xilinx Zynq platform

• SPI programming modes 0/2 up to 30Mbit/sec, modes 1/3 up to 2Mbit/sec

• Fully supported by Digilent's Adept software and Adept SDK

• Board dimensions: 22.75 x 21.5mm

RS Product Codes


• 134-6434 JTAG-SMT2 SMT Module

• 134-6473 JTAG-SMT2-NC SMT Module (without USB connector)

An FPGA is a semiconductor device consisting of a matrix of Configurable Logic Blocks (CLBs) connected through programmable interconnects. The user determines these interconnections by programming SRAM. A CLB can be simple (AND, OR gates, etc) or complex (a block of RAM). The FPGA allows changes to be made to a design even after the device is soldered into a PCB.

Note

This module is not needed for Digilent Xilinx FPGA boards as they have this functionality built-in.

Gerelateerde Links