Honeywell Digital Hall Effect Sensor switching current 20 mA supply voltage 3.8 → 30 V dc

  • RS-stocknr. 370-6896
  • Fabrikantnummer SR15C-A3
  • Fabrikant Honeywell
Datasheets
Wetgeving en compliance
N.v.t.
Land van herkomst: MX
Productomschrijving

SR13 and SR15 series Hall effect sensors

Hall effect sensors in plastic casing with wires.
Flat or quick fit snap-in casing for rapid assembly.
Used in association with a magnet.
Application in various types of detection, low cost.

Specificaties
Kenmerk Waarde
Output Type Digital
Supply Voltage 3.8 → 30 V dc
Terminal Type Wire Lead
Switching Current 20 mA
Length 7.6mm
Width 20.3mm
Depth 5.1mm
Dimensions 7.6 x 20.3 x 5.1 mm
Maximum Operating Temperature +150°C
Minimum Operating Temperature -40°C
98 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
10,21
(excl. BTW)
12,35
(incl. BTW)
Aantal stuks
Per stuk
1 - 9
€ 10,21
10 - 24
€ 7,86
25 +
€ 7,45
Related Products
Hall effect vanes with integrated magnet for detecting ...
Description:
Hall effect vanes with integrated magnet for detecting metal targets.Ideal for detection or counting applications that cannot be carried out with an infrared sensor.For use in dirty and dusty industrial environments.Vertical or lateral mounting, pin or wire output depending on ...
Ceramic based, linear Hall-effect ratiometric devices which produce ...
Description:
Ceramic based, linear Hall-effect ratiometric devices which produce an output voltage proportional to the intensity of the magnetic field to which they are exposed. Three-pin in-line PCB terminals, 0.1in spacingLaser trimmed thin and thick film resistors-40 to 125°C operating range. ...
Sensor for pneumatic cylindersRecords the ring magnets in ...
Description:
Sensor for pneumatic cylindersRecords the ring magnets in the cylinder pistonsPrecise recording of position by means of accurate switching pointsOutput: N/OOutput current max. 100 mAResponse threshold 2.1 mTTraverse speed > 10 m/sPolarity reversal protectionLED status displayConnection lead with plug ...
The Cherry GS1001 series of gear tooth sensors ...
Description:
The Cherry GS1001 series of gear tooth sensors are hall effect sensors that are designed for use in applications where ferrous edge detection or near zero speed sensing is required. Stainless steel housingHigh speed capabilityImmune to rotational alignmentSinking (Open Collector) ...