Megger 1001-977B Loop Impedance Tester 2 Wire Test Lead Set, For Use With LTW 300 Series

  • RS-stocknr. 255-639
  • Fabrikantnummer 1001-977B
  • Fabrikant Megger
Datasheets
Wetgeving en compliance
N.v.t.
Land van herkomst: GB
Productomschrijving

LTW425

The Megger LTW425 two wire earth loop tester verifies the loop impedance of a live electrical circuit, ie without the need to disconnect the electrical supply. Offers a high resolution 2-wire loop testing solution that does not trip 30 mA RCDs and can be used on a wide range of voltages.

High resolution (0.001Ω) 2 wire testing + maxZ + (R1+R2)
Backlit display
2 wire loop tests: Phase to Earth, Phase to Neutral or Phase to Phase
3 phase circuits with RCD protection can be tested
Tests radial circuits where the circuit does not return to the origin, even where only a phase and neutral contacts are available.
10 second non trip loop test time with Auto test extension up to a further 10 seconds if noise is detected, to improve the accuracy of the test
High current loop testing for supplies that do not have an RCD fitted
AUTO START will start the loop test running as soon as the test leads are connected; No need to press the test button means much safer testing
PFC Display up to 40kA
Voltage and frequency measurement
110 Vac systems including 110V centre tap to earth (55 V phase to earth) can be tested on the secondary winding.
IP54 Weatherproof case
Optional 10A fused 2 wired test leads and crocodile clip set
Complies with IEC61010-1 300V CATIV safety standard and meets EN61557

Note

RS is an authorised Megger distributor. Purchased though RS this product is eligible for the Megger extended 3 Year warranty

Supplied with

Test lead set with crocodile clips, mains socket test lead, 8 AA alkaline batteries, hard carry case and instructions.

Specificaties
Kenmerk Waarde
Accessory Type 2 Wire Test Lead Set
For Use With LTW 300 Series
1 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
94,90
(excl. BTW)
114,83
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 94,90
Related Products
Kits for performing tests required by NF C ...
Description:
Kits for performing tests required by NF C 15-1001 DT-170 (differential controller)1 DT-300 (earth and continuity measuring device and extension cord)1 M-9955538 (diagnostic book 15-100)1 DT-500* (Insulation controller and connectors).
Description:
Brought to you by Fluke, a range of Test leads and probes, suitable exclusively for Fluke Multimeters. Whether it's a test lead set or a probe set, dependent on the application, both types will add a sense of reliability to ...
Set of 2 spare leads for DTR8510 and ...
Description:
Set of 2 spare leads for DTR8510 and DTR8500. Length 4.6m.
RS Pro IPT1800 is a great value, microprocessor-controlled ...
Description:
RS Pro IPT1800 is a great value, microprocessor-controlled PSC/loop tester. Its high loop impedance range permits direct measurement of ground spikes. Features include an auto lock-out if the test resister overheats. Large 3 digit 2000 count with analog bargraph LCD200 ...