DIN Rail Diode Module for use with DIN Rail Unit

Datasheets
Wetgeving en compliance
Conform
Land van herkomst: DE
Productomschrijving

Phoenix Contact QUINT DIODE Redundancy Modules

Using a redundancy module, it is possible for two power supply units of the same type connected in parallel on the,output side to increase performance or for redundancy to be 100% isolated from one another.

Decoupling power supply units switched in parallel
Installation in potentially explosive areas is permitted
Load currents up to 60 A are possible
Easy installation by snapping onto the DIN rail

Switch Mode - Phoenix Contact Single Phase and Three Phase Power Supplies

A range of power supplies, which, based on its technical properties and competitive prices, is well suited for panel builders and standard machine production, replacements of existing power supplies or comparable applications.

Specificaties
Kenmerk Waarde
Accessory Type DIN Rail Diode Module
Series QUINT-DIODE/12-24DC/2X20/1X40
For Use With DIN Rail Unit
8 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
42 op voorraad - levertijd is 2 werkdag(en) (UK-voorraad)
Prijs Each
Was € 116,94
104,24
(excl. BTW)
126,13
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 104,24
Related Products
Active redundancy module for superior system availability and ...
Description:
Active redundancy module for superior system availability and maximum operational reliability. QUINT S-ORING enables the separate structuring of a redundant system. In combination with the new QUINT POWER power supply, the redundant system is monitored continuously. Consistent redundancy up to ...
Buffering with service free electrolytic capacitors24V or 48V ...
Description:
Buffering with service free electrolytic capacitors24V or 48V models availableConstant output voltage in buffer modeBuffer time 0.2s at 20A (24V) or 0.1s at 20A (48V)Longer hold-up time at lower levelsBuffer units can be connected in parallel to increase the output ...
Combining a SITOP power supply and a 90° ...
Description:
Combining a SITOP power supply and a 90° mounting bracket results in a minimum surface area requirement on the rear panel of the control cabinet. The width of the power supply becomes the depth, and the depth becomes the width. ...
For N+1 and 1+1 Redundant Systems Dual Input ...
Description:
For N+1 and 1+1 Redundant Systems Dual Input with Single Output Suitable for all Power Supplies Only 72mV Voltage Drop at 20A Output Current Only 2.15W Loss at 20A and 6.3W at 40A Output Current 160% (65A) Peak Load Capability ...