Diode Module, DIN rail, 48Vdc, 20A

Datasheets
Wetgeving en compliance
Conform
Land van herkomst: DE
Productomschrijving

Phoenix Contact TRIO DIODE Redundancy Module

The din rail mounting, Trio Diode redundancy modules from Phoenix contact are designed to isolate parallel-switched PSU’s. Using the redundancy module prevents short circuits affecting the load by checking the wiring from the power supply to the diode.
Using the redundancy module, it is possible for two power supply units of the same type connected in parallel on the output side to increase performance or for redundancy to be 100% isolated from one another.

Features and Benefits

• 100% decoupling of power supply units connected in parallel
• Supports currents up to 30A
• Easy installation by snapping onto the DIN rail
• Reverse polarity protection
• Consistent redundancy up to the load
• Robust design
• Saves space as only 18 mm wide

Typical Applications

The redundant systems are mainly used where the system places a high demand on operational reliability. The PSU must be big enough that the total current requirements of all loads are met by one power supply unit.

Switch Mode - Phoenix Contact Single Phase and Three Phase Power Supplies

A range of power supplies, which, based on its technical properties and competitive prices, is well suited for panel builders and standard machine production, replacements of existing power supplies or comparable applications.

Specificaties
Kenmerk Waarde
Accessory Type Redundancy Module
Series TRIO-DIODE/48DC/2X10/1X20
9 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
50,26
(excl. BTW)
60,81
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 50,26
Related Products
Active redundancy module for superior system availability and ...
Description:
Active redundancy module for superior system availability and maximum operational reliability. QUINT S-ORING enables the separate structuring of a redundant system. In combination with the new QUINT POWER power supply, the redundant system is monitored continuously. Consistent redundancy up to ...
Combining a SITOP power supply and a 90° ...
Description:
Combining a SITOP power supply and a 90° mounting bracket results in a minimum surface area requirement on the rear panel of the control cabinet. The width of the power supply becomes the depth, and the depth becomes the width. ...
For N+1 and 1+1 Redundant Systems Dual Input ...
Description:
For N+1 and 1+1 Redundant Systems Dual Input with Single Output Suitable for all Power Supplies Only 72mV Voltage Drop at 20A Output Current Only 2.15W Loss at 20A and 6.3W at 40A Output Current 160% (65A) Peak Load Capability ...
The TPC series is a family of DIN ...
Description:
The TPC series is a family of DIN Rail power supplies operating with high efficiency to comply with the requirements of the European Ecodesign directive.These DIN Rail PSUs have universal input of 85 V ac to 264 V ac or ...