Phoenix Contact MACX MCR-EX-SL-RPSSI-2I-1S-SP, Current to Current Power Supply Repeater, Current ATEX, IECEx,

Datasheets
Wetgeving en compliance
Conform
Land van herkomst: DE
Productomschrijving

Ex i measuring transducer supply conditioner and input signal conditioner, only output 1 is HART-transparent. Transmits supplied or active signals from the Ex area with electrical isolation to two loads. SIL 2, Push-in connection.

Specificaties
Kenmerk Waarde
Input Type Current
Output Type Current
Signal Conditioner Type Current to Current
Input Range 0 → 20 mA, 4 → 20 mA
Output Range 0 → 20 mA, 4 → 20 mA
Supply Voltage 19.2 → 30 V dc
Mounting Type DIN Rail
Minimum Operating Temperature -20°C
Maximum Operating Temperature +60°C
Series MACX MCR-EX-SL-RPSSI-2I-1S-SP
Number of Channels 1
Termination Push-In
Operating Temperature Range -20 → +60 °C
Module Type Repeater Power Supply
Hazardous Area Certification ATEX, IECEx
1 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
337,45
(excl. BTW)
408,31
(incl. BTW)
Aantal stuks
Per stuk
1 +
€ 337,45
Related Products
Single channel signal processors for use with insertion ...
Description:
Single channel signal processors for use with insertion flow sensors that do not have internal control logic options available with digital or analogue output. Finger protectionLED indication of flow conditionsSimple switch point set up using potentiometers500Ω load (max.)PNP Output8-pole, 18mm ...
Can be mounted on DIN rail individually or ...
Description:
Can be mounted on DIN rail individually or with other units. The housings are 102.5mm high by 6.2mm wide. The performance specifications are similar to standard sized MCR products. Input, 2 x 24 VDC supplyIntegrated diode decoupling of power suppliesOutput, ...
Can be mounted on DIN rail individually or ...
Description:
Can be mounted on DIN rail individually or with other units. The housing is 102.5mm high by 6.2mm wide. The performance specifications are similar to standard sized MCR products.,Requires a 24Vdc supply, either directly to module terminals or via a ...
For controlling Ex-i solenoid valves, alarm modules or ...
Description:
For controlling Ex-i solenoid valves, alarm modules or LEDs installed in Ex areas Current limitation at 48 mAFor gases up to Group II C, loop-powered, electrical isolation, SIL 3Housing material polyamide (PA 6.6).