HARTING Han C Male Crimp Contact, 40A Minimum Wire Size 1.5 mm² Maximum Wire Size 1.5 mm² for use with Heavy Duty Power

This heavy-duty power connector contact provides a secure electrical connection for industrial power assemblies. Designed as a crimp contact for use in heavy-duty connectors, it facilitates reliable insertion into compatible housings and supports high-current power distribution in demanding electrical and automation environments.

• Rated for continuous operation at 40 A to handle high current loads
• Silver-plated copper alloy contact surface to reduce contact resistance
• Crimp termination for consistent mechanical and electrical joint quality
• Accepts 1.5 mm² conductors to match standard cable gauges
• Insulation coordination up to 830V for elevated voltage applications
• Meets IEC 60664-1 requirements for specified insulation performance

• Suitable for power distribution in factory automation cabinets
• Used with motor control units in industrial machinery
• Ideal for connecting power modules in electrical switchgear
• Can be used for on-site maintenance of heavy-duty connector assemblies

Strip the conductor to expose sufficient copper for a full crimp barrel fill and use a compatible crimping tool rated for 1.5 mm² cross-section to ensure correct compression and electrical contact.

The silver plating offers low contact resistance and improved conductivity, it also provides a degree of surface protection which helps maintain consistent performance where mild atmospheric corrosion may occur.

It is a male component that uses a crimp termination style intended for insertion into the mating female receptacle within heavy-duty connector housings.

The contact is designed to satisfy insulation coordination requirements specified under IEC 60664-1 and is suitable for systems operating up to 830 V.

Han-Com® inserts have mixed power and signal formats. A typical identifier is ’4//2’ which means there are 4 power contacts and 2 signal contacts. The current rating is different for each type of contact within a particular insert.

UL, CSA, SEV

These connectors should not be mated or unmated under electrical load. Connectors of the same or different types arranged in a line should be polarised to prevent the possibility of wrong connection.