Recom RELI-DA01/R Dali to Analogue Interface for use with RECOM AC/DC LED Drivers

  • RS-stocknr. 811-7355
  • Fabrikantnummer RELI-DA01/R
  • Fabrikant Recom
Datasheets
Wetgeving en compliance
Conform
Land van herkomst: CN
Productomschrijving

Signal Converter for DALI Controlled LED Lighting

The Recom RELI-DA01/R signal converter is an essential link between dimmable LED drivers and DALI components from devices like switches, dimmers and sensors. The converter communicates with the DALI controller, receives commands and converts into PWM, 0-10V or 1-10V signals. The control output can hold up to 6 LED drivers and a built-in relay can be used to switch off the LED drivers under software control, to give zero no-load consumption. The RELI-DA01/R has a wide input voltage range of 90 to 264 Vac which make it suitable to be used worldwide.

Compliant with DALI Standard
Screw less connectors, easy to install
Selectable output for PWM, DC 0-10V, DC 1-10V
Built in relay to turn ON/OFF (zero standby current)

Standards

IEC 62386-102
IEC 62386-206

Recom LED Drivers

Specificaties
Kenmerk Waarde
Accessory Type Dali to Analogue Interface
For Use With RECOM AC/DC LED Drivers
41 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
39,68
(excl. BTW)
48,01
(incl. BTW)
Aantal stuks
Per stuk
1 - 4
€ 39,68
5 - 9
€ 38,09
10 - 24
€ 37,30
25 - 49
€ 36,51
50 +
€ 35,71
Related Products
Ready-for-use resistor to set output current valueCompatible with ...
Description:
Ready-for-use resistor to set output current valueCompatible with LED Driver featuring I-select 2 interface, not compatible with I-select (generation 1)Resistor is base isolatedResistor power 0.25 WCurrent tolerance ± 2 % additional to output current toleranceCompatible with LED Driver series PRE ...
RGB-RP is a RGBW LED Power Repeater designed ...
Description:
RGB-RP is a RGBW LED Power Repeater designed to enable the installation of additional LED tapes within one application. This 6-24V DC/DC unit provides one 4A white and three 2.5A output channels so that the white of an RGBW tape ...
The DMX Bridge can be used to integrate ...
Description:
The DMX Bridge can be used to integrate analog DC dimmer signals into LEDSync or DMX network. The DMX bridges are ideal for retrofitting existing lighting installations. The Pro version offer parameter settings for maximum flexibility and system integration. The ...
The Recom REDIM Triac Dimmer reliably operates with ...
Description:
The Recom REDIM Triac Dimmer reliably operates with low input power. These Dimmers are ideally matched to the RECOM RACT20 LED drivers series and provide a smooth dimming curve and deep dimming down to zero. The Triac Dimmer is designed ...