SKF P2BTC 25M-CPSS-DFH Pillow Block Bearing -, 25 mm ID

This pillow Block bearing provides a mounted support solution for rotating shafts in industrial settings. It houses a cylindrical bore insert to accommodate 25mm shafts and is constructed from stainless steel for use in environments where corrosion resistance is required. The unit features a closed-end design and is intended for applications that demand a compact, bolted housing with a moderate operational speed limit.

• Dynamic load capacity of 11.9 kN delivers controlled radial support
• Static load rating of 7.8 kN resists heavy standstill loads
• Limiting speed of 700 r/min suits low-to-moderate rotational systems
• 36.5mm centre height aligns with common shaft heights

• Suitable for conveyor drive shafts in light automation systems
• Ideal for motor mounting in electrical control panels
• Used with small gearbox output shafts in machinery frames
• Can be used for guiding rollers in PCB assembly lines
• Suitable for support of shafts in lab-scale test rigs

The insert is locked in place using set screws that clamp the shaft and maintain positional integrity under radial loading.

The housing is MADE from stainless steel, which provides resistance to corrosion and reduces the risk of surface degradation in humid environments.

The bearing assembly measures 81mm in length and uses a two-bolt configuration with a 51mm centre-to-centre spacing for secure, space-efficient fixing.

Use the two-bolt flange with correctly torqued fasteners and ensure shaft alignment during installation to reduce eccentric loading and premature wear.